Electronics Forum: osp wave solder (Page 1 of 509)

osp finish

Electronics Forum | Wed Jan 21 16:55:22 EST 2004 | patrickbruneel

Hi, Are you testing bare boards or soldered boards. Are the test probes in contact with soldered pads or contacting the copper with the osp coating (not soldered). If you could clarify this it would be easier to give some hints for probable causes.

osp finish

Electronics Forum | Wed Jan 21 17:43:04 EST 2004 | Kris

Hi, I had the same question. In our case we are contacting the copper with the osp coating (not soldered). any published reports that we can reference Thanks

osp finish

Electronics Forum | Thu Jan 22 09:21:45 EST 2004 | davef

Oh, another thing, we do not like to probe copper. It's hard, compared to solder, and beats-up the probes too much. [As Patrick Bruneel states in this thread.] Consider reflowing paste on your test pads.

wave solder

Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason

I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on

wave solder

Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens

Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w

Selecting wave solder

Electronics Forum | Fri Jun 02 11:07:45 EDT 2017 | soldertraining

I think SEHO GoWave 1030 is better than ERSA ETS 330. The SEHO GoWave 1030 is a powerful soldering system for mass soldering applications. It's used for all types of soldering.

wave solder fingers

Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni

Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks

Cleaning wave solder pallets.

Electronics Forum | Wed Jun 25 12:58:38 EDT 2008 | paul_bmc

How do you clean wave solder pallets of fluxes in your facility?

Cleaning wave solder pallets.

Electronics Forum | Wed Jun 25 13:31:57 EDT 2008 | toddl

Our wave solder pallets are cleaned via our inline board washing machine.

Re: wave solder process

Electronics Forum | Thu Jun 17 13:51:32 EDT 1999 | Kelly Morris

| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.

  1 2 3 4 5 6 7 8 9 10 Next

osp wave solder searches for Companies, Equipment, Machines, Suppliers & Information

See Your 2024 IPC Certification Training Schedule for Eptac

Reflow Soldering 101 Training Course
2024 Eptac IPC Certification Training Schedule

Wave Soldering 101 Training Course
PCB Handling Machine with CE

Best Reflow Oven
SMTAI 2024 - SMTA International

Stencil Printing 101 Training Course