Electronics Forum | Tue Jun 11 18:00:55 EDT 2024 | redspare1
I don't think it will. This was 2.0D Thanks
Electronics Forum | Thu May 31 21:45:48 EDT 2012 | davef
rsthompson ... if you're talking about bare boards IPC-5701, Users Guide for Cleanliness of Unpopulated PBC, Table 8 ||Bare board final surface finish Ions||Hot air solder level||OSP over copper||Gold over nickel Chloride||0.75 ug/cm^2||0.75 ug/cm^2
Electronics Forum | Mon Jan 03 09:10:46 EST 2005 | russ
That would be a 2012 (2.0mm x 1.2mm) in accordance with standardized naming convention.
Electronics Forum | Thu Mar 15 22:17:17 EDT 2012 | daniel26
AMS 2.0 contact assemblon its expensive but works great for our machines.
Electronics Forum | Wed Dec 21 20:41:49 EST 2016 | epcb2016
1.5mm pad is not so ok in practice. You may expand the size to 2.0mm.
Electronics Forum | Mon Mar 25 10:37:15 EDT 2024 | wippsen
Area Ratio Calculator V2.0 von Dek
Electronics Forum | Tue Jun 11 17:56:22 EDT 2024 | ttheis
I have Wincon 1.04E from our VIP70; not sure if that will work for you.
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Thu Apr 04 16:38:51 EST 2002 | davef
Equipment companies like to talk about �accuracy� and �repeatability�. These measures provide limited information. Flaws of the measure aside, some printer companies have begun to report Cp. * DEK ELA: Cp = 1.33 @ �0.025mm * DEK 265: Cp = 1.6 @ �0.0
Electronics Forum | Wed Sep 16 03:17:47 EDT 2009 | geb
The solder wire uses a ORL0 flux. The wire contains less flux at around 2.0-4.0%.
.gif)
winsouce.jpg)
