Electronics Forum | Wed Jun 05 21:33:12 EDT 2002 | davef
Tough to say based on what you have told us. Things to Determine are: * Is the heat at the solder connections that are not reflowing properly adequate? * Is the pad surface of the solder connections that are not reflowing properly solderable?
Electronics Forum | Wed Sep 25 13:38:35 EDT 2002 | finepitch
Yannick, If we leave the 201 issue aside; have you checked where those BGA pads are connected to? Could those be power/ground balls connected to large (difficult to heat up) planes by any chance? Erhan
Electronics Forum | Wed Jun 05 17:13:58 EDT 2002 | Yannick
Hello! I have a strage problem, we made some production with uBGA, BGA, 0201, 0805, and other type of component. We didn't put the uBGA and 0201 and BGA on the board at the end of the line we look a our solder joint and surprise the solder made a
Electronics Forum | Tue Dec 13 17:41:04 EST 2011 | davef
A Study Of 0201’s And Tombstoning In Lead-Free Systems, Phase II Comparison Of Final Finishes And Solder Paste Formulations http://sheaengineering.com/Documents/APEX%2008%200201s%20and%20Tombstoning%20phase%202%20paper.pdf CONCLUSION The condition
Electronics Forum | Fri Jan 06 05:03:11 EST 2012 | richieoreilly
Hi All, Just wondering if anyone is placing 0201 components in volume. If so What pad layout are you using, i.e. pad size, shape and spacing. Also are you pads and fiducials solder mask defined or copper defined. Can you also let me know the rough q
Electronics Forum | Fri Jan 06 13:47:15 EST 2012 | davef
Your starting [and finishing] point should be IPC-7351B Land Pattern Calculator and Tools - http://landpatterns.ipc.org/default.asp For more, look here: * http://www.smtnet.com/bob-willis/pbdai.html * http://www.onboard-technology.com/pdf_novembre
Electronics Forum | Tue Sep 14 05:46:51 EDT 2021 | denism
To measure two 0201 pads, you need to solder two thermocouples for each component pin on different segments. Thermocouple wire should be 36AWG.
Electronics Forum | Mon Aug 24 21:43:28 EDT 2009 | davef
In reworking 0201, we: * Cut the 0201 in half with a side cutter * Heat the solder on each pad separately and flick the half 0201 off the board * Preheat a new component to +150°C with a hot plate * Solder a new 0201 on the undressed pads with a hot
Electronics Forum | Tue Dec 13 09:29:08 EST 2011 | swag
We're soon to build a lead free assembly with 0201 components. I'm not worried about placement as our machines can handle it. Any tips on printing, screens, reflow?
Electronics Forum | Wed Sep 25 06:56:16 EDT 2002 | CH
U may check your profile ramp rate. The flux may evporated and look like cold joint