Electronics Forum | Mon Aug 02 09:49:12 EDT 2010 | vetteboy86
My problem is that a 10k 0805 chip looks fine next to a 100k 0805 that is brown.
Electronics Forum | Thu Jan 24 04:54:43 EST 2002 | wbu
Well Greg, I don�t know YOUR 0805 Pads but if you look at the recommended pattern for 0805 in IPC-SM-782 you might notice that the Z-dimension is somewhat about the size of your 1206 part length. With that and assuming that you ask if the results wi
Electronics Forum | Tue Jun 27 10:51:42 EDT 2000 | Ioan
Hi Bill, there are a couple of things you should check. Most likely you have too much paste which is squashed at the insertion of the cap. - the paste height, around 7 mils should do. Too much paste will cause shorts under the cap at insertion which
Electronics Forum | Thu Aug 23 15:45:48 EDT 2001 | slthomas
So, we've already addressed the tombstoning on these guys by adopting the mfr's (Pana.) recommendations for pad size and spacing. Problem is, we have pretty bad wetting of some of these parts. The rest of the board we use them on looks great, nice
Electronics Forum | Mon Aug 27 10:58:44 EDT 2001 | Ryan Jennens
Steve- We had the same trouble with 0805 Panasonic film caps. We had some tombstoning and open solder joints (non-wetting). We found two problems...like you, we changed our pad design to meet their recommendation. Also, they were able to suppl
Electronics Forum | Thu Aug 23 16:41:06 EDT 2001 | slthomas
Naw, the rest of the BOARD we use them on. Same assembly. Actually we use them on one other assembly and have the same problem. Same oven, same line, same paste, same problem. I've tried to get the production super. to move them to another line w
Electronics Forum | Mon Nov 25 09:45:29 EST 2013 | processman
Are you using zestron corrision inhibiter Ci20 also?
Electronics Forum | Wed Nov 27 06:06:59 EST 2013 | luciano
Thanks!
Electronics Forum | Fri Dec 06 06:02:25 EST 2013 | luciano
Thanks for the advice!
Electronics Forum | Thu Nov 21 12:06:16 EST 2013 | rgduval
The last time I got corroded parts out of my wash was when my DI tanks were spent, and I was pretty much using straight tap water. Refreshing the DI tanks eliminated my issue. Hope this helps. cheers, ..rob