Electronics Forum | Mon Feb 10 15:39:20 EST 2003 | bpan
Thanks for all the info guys. Dont think that the problem is a thermal one and I believe the guys designing the board just need to design them out. I have directed the customers we get the boards from to read this posted question so that they could s
Electronics Forum | Wed Feb 05 11:10:01 EST 2003 | J. Dumont
Is anyone looking for any PCB assembly work to be done?? We currently build all our boards for our many world class products in house and will possibly be branching into building assemblies for outside companies in the near future. Pricing will be ve
Electronics Forum | Thu Feb 13 10:38:51 EST 2003 | davef
Given that you are bridging front to back, contast the situation with the thiefs used to prevent bridging when wave soldering SOIC. If this is reasonable, the thiefs should be located behind the trailing connector pins. You can prove-out this [and
Electronics Forum | Wed Feb 12 17:10:02 EST 2003 | Mike G
Most conveyors are sold by the inch. I allow for no more than one inch gap between the end of the conveyor and the next piece of equipment. If you trust your measurements, 1/2 inch is best. This will allow for the smoothest transfer possible of small
Electronics Forum | Fri Feb 21 10:31:48 EST 2003 | adlsmt
We dont have the debridging knife. I had one on an old Hollis machine I had once. It was totally worthless. I am setting up the nitrogen today. I will let you know how its goes. We are using a water based no-clean. The nitrogen will probably make a
Electronics Forum | Fri Feb 21 10:00:38 EST 2003 | ghenning
I would appreciate any feedback that can be provided regarding best practices and common practices for control of incoming PCB blank quality. How common is sectioning and other sorts of analysis? Do these efforts result in real improvements in vendo
Electronics Forum | Mon Feb 24 10:15:56 EST 2003 | JF
I'm triying to upgrade the software on my Qsa-30A(V) going from version 5.4 to version 6.6 and I'm having lot of problems, my machine will just not respond to any command does anyone knows how how to jump from one versio to another one with out any p
Electronics Forum | Tue Feb 25 20:10:33 EST 2003 | davef
First, there is no standard. Next, on one hand, most BGA cost a lot of money. On the other hand, choosing to use reballed BGA in products for shipment depends on how well you expect to meet your customers' expectations about product reliability wit
Electronics Forum | Mon Mar 03 10:19:57 EST 2003 | jseagle
We just got Red-E-Set from Production Solutions for our DEK ELA printer. It is a similar concept, it's mechanical instead of hydralic or pnumatic. The print results are very good and the operators love how easy they are to setup. I am planning on
Electronics Forum | Mon Mar 10 18:29:00 EST 2003 | Stephen
May I be the first to ask, how you plan on applying paste to the primary SMT? You won't be able to stencil it on as is typical. Do you have a paste dispenser? Also a lot of PTH parts can not take reflow temperatures, not even all SMT parts can. (b
