Electronics Forum | Wed Feb 10 15:55:19 EST 2021 | ttheis
We just use a ramp to a cart and the line operator loads them into trays as they come out. There are buffer conveyors or magazine loaders you could use. Or do a little industrial automation with a plc and proximity sensors; combine a ramp and a belt
Electronics Forum | Tue Feb 09 10:34:53 EST 2021 | jamesn
Hello Gents I have a problem with the head on gantry 2. I think it needs replacing but in the meantime Can anyone on the forum tell me how to disable it so the machine will initialise and run gantry 1 Ive been told it can be done but they cant rememb
Electronics Forum | Sat Apr 10 03:46:55 EDT 2021 | ttheis
Thanks for all of the comments and information. We ended up going with the AC-30L. We ran our first sticky panel once it was installed this week. It is a very impressive machine. I think it will do well for us in this application. Hopefully it treats
Electronics Forum | Sat Apr 10 00:19:06 EDT 2021 | mi123ms
I just purchased an Assembleon Sapphire machine and am new to Assembleon machines, and on startup it states "Download Vision Data NG", does this mean the processor board can't download the vision data to the vision board? I have spare boar
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Wed Apr 21 23:05:37 EDT 2021 | duchoang
We have an YXLON Cougar X-Ray machine. Run good in 10 years. Now, when we started the machine as usual, the machine run START-UP process, Manipulator Reference OK, Vacuum OK, but not "Warm Up", the X-Ray keep turning off and on showing Voltage ~50KV
Electronics Forum | Tue Apr 27 10:40:36 EDT 2021 | mikekeens
Hi, I'm currently in the process of evaluating a number of 3D AOI machines such as Koh Young Zenith Alpha HS+, CyberOptics SQ3000, Mirtec MV-6 Omni, Parmi Xceed L and Aleader ALD8720S. Does anyone have any thoughts on these machines as to which is b
Electronics Forum | Mon May 10 12:04:50 EDT 2021 | rsikora
Thanks for your reply. I haven't checked or used WinMCS for troubleshooting. Based on your reply, I looked or WinMCS within Explorer and could not find it. Used the autosearch function for "MCS" and "WinMCS" and the autosearch did not find it eith
Electronics Forum | Sun Jun 27 21:10:07 EDT 2021 | damiendigilin
We changed the encoder because the ribbon cable is soldered to the board. Both encoders seem to be working correctly beep tested the cable. We have tried different size components 0603,0805,1206 and different boards. It will place about 3 to 5 com
Electronics Forum | Mon Jul 12 20:26:10 EDT 2021 | stephendo
A test that I would like to see is, expose parts for 24 hours 40%-60% RH, 25C for 24 hours. Then seal with a HIC and minimum desiccant that Jstd 33 requires. Five to seven days later open and see if HIC says good but parts have excess moisture. I t