Electronics Forum | Sun Aug 21 15:35:22 EDT 2022 | zadir
good afternoon, please tell me, maybe someone has encountered a problem on the juki 730/740 machine.we have a 24 volt 10 amp power supply broken on it (it stopped turning on completely) we changed it, but now stanou can't find the zero point, he come
Electronics Forum | Fri Aug 26 10:44:37 EDT 2022 | gfe
In the Mirae machine we can give an individual delay for each component, in this case the delay in Z is in all of them, the nozzle stays on top of the component for a long time, this happens in any program, could we have accidentally changed some con
Electronics Forum | Tue Oct 11 06:52:44 EDT 2022 | gui
Hi, I have 2 SMD lines, one composed by SM 471, SM 482 and the other one by SM 482. At this point I'm trying to get an OLP to configure everything from an offline position. Some people have talked me about Samsung T-Olp but I don't know where can I
Electronics Forum | Wed Oct 12 17:45:07 EDT 2022 | rmcmartin
I received an error message from our Sony F209 pick and place machine saying E17 servo controller is in emergency stop. It says the remedy is to cancel the input or replace the cable. where is the E17 servo controller and how do you cancel the inpu
Electronics Forum | Thu Oct 13 18:20:14 EDT 2022 | proceng1
I also believe it is the cause of the issue. I guess you could make a fixture that clamps the board flat. Then you'd have to change the reflow recipe. How was the recipe created? Did you actually profile a populated board or just use a recipe that
Electronics Forum | Tue Oct 18 07:02:47 EDT 2022 | poly
The product editor complains if I have a part that overhangs the edge of the board. Any hints on how to fix this? Set the "board" size bigger than the actual board and the use an offset to make it in the right place? Or is there a better way to say t
Electronics Forum | Tue Oct 18 15:50:01 EDT 2022 | smith88
IPC states chips and cracks in glass body are defective if beyond specifications. Chips or cracks in glass body beyond the part specification, see Figure 9-18. • Cracked or damaged glass bead beyond part specification (not shown). On some glass
Electronics Forum | Wed Oct 19 00:17:53 EDT 2022 | proy
Has anyone here experience with re-purposing a Camalot dispenser (dos based 90's vintage)? It is a really robust and accurate gantry, would like to create programs to raise and lower a spindle mounted to the head - the 1414 I have has fudicial camer
Electronics Forum | Wed Oct 19 14:03:47 EDT 2022 | proceng1
Low Temp solder and a cooler profile should certainly help. I do believe that the unbalanced copper is the culprit, but you could try to prebake some boards. To eliminate some kind of manufacturing defect from the equation. Though I'm pretty sure i
Electronics Forum | Wed Oct 19 14:15:43 EDT 2022 | proy
Thank you all a but the easy fix - of correcting copper - is not an option -actually no changes to the board can be done simply they way it is.... I will look at post reflow bake above TG but I don't want to add a process.... Will look at profile als