Electronics Forum | Wed Dec 10 09:29:59 EST 2008 | rgduval
Oops...just noticed you were referring to wave soldering. We'd still suggest a water-soluble flux, instead of the no-clean; especially at wave soldering. Also, checking pre-heat temps, and dwell time on the pot. Is the wave a chipper wave? If not
Electronics Forum | Sun Dec 14 13:52:10 EST 2008 | tsvetan
you may check http://www.manncorp.com MC-391 (I saw they have banner here), we have same bought here in Europe under the brand Autotronik, this is made in China machine. Very easy to use and very cheap. with vision centering and good precision, not s
Electronics Forum | Tue Dec 16 10:59:50 EST 2008 | patrickbruneel
Here's a new ban proposal by the EU on the flame retardant deca-BDE. A product that has kept our electronics safe for over decades. The good part is that the scientific community in the EU looks like to put up a bigger resistance as was the case wit
Electronics Forum | Wed Dec 17 04:22:10 EST 2008 | bing007
The supervisor password is set and the current password is not known. I need to reset this. Is there a top level password above the supervisor level that can be input to enable me to access the machine data without clearing all the machine data out?
Electronics Forum | Wed Dec 31 14:10:33 EST 2008 | kmakiya
We are in the northwest and there was no state requirement for technician certification. The DoH encourage all to register their xray equipment with them and that was about it. We had their physicist come to our site to do leakage tests every time we
Electronics Forum | Tue Jan 13 10:35:06 EST 2009 | evtimov
konrad, why did you change your mind now? Now you can agree with PCB manifacturerers? I didn;t hear anything in their defense and you gave up. If colour is not the same each time, that means they don't have standarts or knowledge to control it, an
Electronics Forum | Tue Jan 06 15:02:06 EST 2009 | tech1
With this current downturn how many of us are worried about our jobs? It wasn't that long ago (00/01)since the last one and just trying to get an idea on how bad this one is going to be. We slowed down middle of last quarter and I think the worst is
Electronics Forum | Thu Jan 15 10:33:05 EST 2009 | rrpowers
One thing you must be very careful with when using Bismuth is that there is no lead anywhere else within the process, either components or boards. Lead-terminated components or hot air solder leveled (HASL) finished boards used in combination with a
Electronics Forum | Thu Jan 22 11:07:14 EST 2009 | boardhouse
Hi Jeff, Unfortunately there is just as many bad shops in the US. Communication & doing your Due diligence is the best solution. I sell for Taiwan now but sold for a US shop for 10 years. Taiwan Quality is as good or better than most US Shops and
Electronics Forum | Tue Apr 07 13:17:10 EDT 2009 | tserra
I would recommend looking at SAKI/MacroScience. http://www.xraytechnology.eu/index.php?option=com_content&task=view&id=34&Itemid=42 I have seen the images created by MSX3000 from MacroScience which is now under SAKI and can tell you with certainty