Electronics Forum | Wed Jun 09 15:54:16 EDT 1999 | Glenn Robertson
| | Does anyone have thoughts on BGA rework. We now use the OK BGA 3000 and now am considering an Infrared machine. Any thoughts? | | | I've used Pace, Conceptronic and, now, SRT machines. Bottom side IR is OK. Better thermal balance is achieved wit
Electronics Forum | Mon Jun 07 10:52:04 EDT 1999 | Brian Wycoff
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
Electronics Forum | Fri Jun 11 16:21:33 EDT 1999 | Dan Perkins
|Jason, The stroke of the cutter blade cam rod is fairly tight, is machine making loud clunking noise when it stops? If so stoke may need to be adjusted. Send me an email if you would like to talk. dan |Yes, I am aware of this machine being a Sa
Electronics Forum | Fri Jun 04 23:44:07 EDT 1999 | Dean
| | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks |
Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Sat May 29 22:10:28 EDT 1999 | Earl Moon
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Tue May 18 14:47:02 EDT 1999 | Dave F
| Looking at the full convection reflow oven market, I see two segments, high mass heater ovens (i.e. Electrovert Omniflow,...), and low mass heater ovens (i.e. Heller,...) | Did some of you guys did some testing on both types and what were your find
Electronics Forum | Sun May 16 10:11:50 EDT 1999 | M Cox
| I'm running memory module product- SMT double reflow ( 12 modules per panel). I'm using the epoxy base solder paste in order to reduce the flux spattering problem onto the gold finger which could lead to the intermittent contact problem. | | I do