Electronics Forum | Thu Oct 23 13:38:30 EDT 2008 | fede
Hi, This week I received a newsletter from the people from High-Tech Conversions, offering an under stencil wipe which needs only water to activate its and clean. My question is, did any body tried it? Is it better than cleaning with solvent?
Electronics Forum | Thu Oct 23 18:39:41 EDT 2008 | kiter
Was wondering if anyone has a general chart matching SMT package size with tape feeder size. E.g 0602: 8mm Tape 2mm pitch. Cheers.
Electronics Forum | Wed Oct 29 07:48:20 EDT 2008 | davef
Our old friend Bob Willis runs a site aimed at making ppm for electronic assembly process better known. Look here: http://www.ppm-monitoring.com/
Electronics Forum | Wed Oct 29 07:52:42 EDT 2008 | ikonify
Thanks Dave, did send an email to this site as wanted some industy standard PPM levels but my email bounced back. Will give it another go. Thanks for taking the time to reply !!! Steve.
Electronics Forum | Thu Oct 30 19:59:05 EDT 2008 | gregoryyork
solder ball was caused by hasl process not reflow. seen before many times, look around wells of smt on bare boards should be more of them
Electronics Forum | Mon Oct 27 12:19:43 EDT 2008 | evtimov
Hello all, can anyone tell me where I can buy front connectors for UIC feeders? Or at least the probe pins. From Universal connectors cost a small fortune. Emil
Electronics Forum | Mon Oct 27 15:17:16 EDT 2008 | dwelch123
I assume your talking about GSM feeders, and your right, they do cost a small fortune. You would be better off trying to buy used feeders,,at this point they are everywhere and pretty cheap.
Electronics Forum | Tue Oct 28 13:07:09 EDT 2008 | evtimov
Yes dwelch, mostly GSM feeder, some Advantis feeders have same connector indeed. There has to be another opportunity. Somebody is doing that for them anyway.
Electronics Forum | Fri Nov 07 13:59:10 EST 2008 | bigdaddysoy9
Andrew, Can you please explain the difference between rules based and image based inspection philosophies?
Electronics Forum | Tue Oct 28 12:02:11 EDT 2008 | milas
Hi We have recently specified the following on a bareboard that has an ENIG finish. Does it sound about right or is it likely to give me problems ? Nickel : 3uM � 7uM Gold : 0.05 uM � 0.1 uM Thanks in advance