Electronics Forum | Fri Oct 02 12:57:13 EDT 2009 | dnebel
Looks like you'll need to reset the controller. That will require turning the Run/Halt swith to Halt and back to Run. That should put an @ prompt on the screen. There is a list of inputs you continue through to reinitiate, but I have forgotten the
Electronics Forum | Mon Oct 05 08:32:11 EDT 2009 | jeffharley
Make sure you have DC ok light on, on the EMI/PS card slot one. If not check your DC voltages at the card...5,15+,15-,12 v dc. if your voltages are not there then the machine will not run.
Electronics Forum | Thu Oct 08 21:29:31 EDT 2009 | stevezeva
I don't think NEA is around anymore. I know of a great guy named Don Burshnick at a place called SMT Technologies that used to build Universal machines and knows them like the back of his hand, call him at: 607-772-2900. Steve
Electronics Forum | Tue Oct 13 08:49:09 EDT 2009 | kudamarani08
try "halt" your EMI and check if the @ appear on screan. If yes, type G or P to re-start the system. If NO, make sure 5VDC is present. V2 controller really a tricky one.
Electronics Forum | Tue Oct 13 19:15:59 EDT 2009 | fulldrawmike
if you have not turned the halt switch down then back up you can sometimes get a restart using 0(zero)G and enter. If that does not work you will have to load the exec.
Electronics Forum | Mon Oct 05 05:08:45 EDT 2009 | pengliang
Hello we'll share DFX Design Guideline as attached i hope dicuss with you MSN:liang.pung@hotmail.com
Electronics Forum | Mon Oct 05 06:08:02 EDT 2009 | pengliang
hello, I'm Pengliang,from China job in ASUS computer and working with smt process department.(so I hope to dicuss the process issue analyse and improvement) any issue pls. pass out . msn iD: liang.pung@hotmail.com good luck
Electronics Forum | Fri Oct 30 13:23:26 EDT 2009 | rajeshwara
Hi Rajesh from India Working as a SMT Process Engineer in Major Consumer Electronics Giant Videocon. mail me at smtschool@gmail.com
Electronics Forum | Wed Oct 07 07:47:32 EDT 2009 | nagesh
Dear ALL, Which machine is the best cost effective in the Pre-Reflow stage.(Programming lead time/Inspection capabilities) Whether it is AOI from Omron or ViTech. Thx in advance for all your sincere postings. Cheers, Nagesh
Electronics Forum | Mon Oct 12 13:09:30 EDT 2009 | bigdaddysoy9
Nagesh, I haven't worked with an Omron machine, so I can't comment on that. We use VI and are extremely satisfied with their performance.