Electronics Forum | Thu May 05 14:19:10 EDT 2022 | emeto
It is just a quality check, so it is not a MUST per say. It is really nice to have. To benefit from it though, you should have a good understanding of it and monitor results constantly. SPI really help you understand your printing process and investi
Electronics Forum | Wed May 18 05:10:09 EDT 2022 | dilogic
What kind of part is it? Looks like resistor. On the second image, light seems to be too bright for my taste.
Electronics Forum | Mon May 23 10:15:05 EDT 2022 | FSTechnology1
This is my first post. I just graduated from college and entered the circuit board industry, but I am not familiar with this industry at all. I studied public utility management in college, I hope someone can give me some advice.
Electronics Forum | Mon May 30 10:06:03 EDT 2022 | leeg1
If you have the HLC software you can recombine programs and output the pick and place file as a text file
Electronics Forum | Mon May 30 10:08:22 EDT 2022 | leeg1
Hi, I have quite a bit of experience with programming of the 700 series, email me if you need anything.
Electronics Forum | Wed Jun 01 10:22:56 EDT 2022 | pradeep14
Hi all, Please explain me how the PICK & PLACE program verification can doing in your organization and what are procedures following. Thanks in advance
Electronics Forum | Fri Jun 10 17:55:16 EDT 2022 | jdengler
Generally we overprint on the exposed part of these pads. When there isn't enough clearance at the end of the pad we place solder preforms with the placement machine. Jerry
Electronics Forum | Fri Jun 10 19:02:57 EDT 2022 | llawrence
Yes they are far from ideal. What do you mean by profiling on the problem leads? And yes there is a lack of solder on some, but there are no vias in or near any of the pads that could be stealing solder
Electronics Forum | Fri Jun 10 19:05:23 EDT 2022 | llawrence
Overprint, that is putting extra solder on with the stencil that is even further out from the pads, with the idea that it will suck that solder up during reflow? I could give that a try. Are there any general recommendations when overprinting? And wh
Electronics Forum | Fri Jun 10 23:24:02 EDT 2022 | llawrence
Ah okay, that should be pretty easy to do on the current board design. If overprinting doesn't work, then I might try a preform. I wasn't even aware that was a thing, I might be able to do some of our through-hole components that way if they are rate