Electronics Forum | Thu Aug 04 22:02:25 EDT 2011 | fujiphil
IP3 camera calibration, you need the following: 1. Part camera resolution Jig. 2. 10mm nozzle for nozzle centering. 3. Button jig (skip). 4. Glass board and Glass parts. 1. Conduct the Camera resolution. Set the following Delta values: X=+/-0.1mm;
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Mon Oct 10 11:21:18 EDT 2011 | fishingfool
Pit I have been in capital equipment for 20 years. I have been in sales and service both. Very few companies make money from service. In your scenario would the company have spent 4 or 5 days on the phone with you? These systems can be tricky if
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Fri Mar 09 04:10:18 EST 2012 | grahamcooper22
Hi, I've been supplying Totech dry cabinets in the Uk for 10 years and in that time I've realised the only places to find the correct MSL level is on the dry pack the devices are shipped in or by spending hours on the internet or speaking to the devi
Electronics Forum | Fri Feb 03 17:25:47 EST 2012 | tombstonesmt
We've been having issues with our current process of oven profiles. We use a high temp adhesive to bond the thermal couples to the desired components. The issue of them letting go or releasing during reflow temps are hit or miss. Majority of our buis
Electronics Forum | Mon Jul 23 08:35:33 EDT 2012 | grahamcooper22
The lower the RH in the MBB the better for all moisture sensitive devices. Maintaining less then 5% will mean no parts of between 2a-5a MSL will need drying before use. The calculation uses 10% because it is a sensible amount of desiccant to use base
Electronics Forum | Fri Oct 19 10:02:34 EDT 2012 | ericrr
First, why is there appears to be no marking on simple capacitors when there is a code for, yet there is markings on resistors? Attached is a interesting table, it came about after I spent hours and hours and hours looking on Internet from a 16 Volt
Electronics Forum | Tue Dec 11 10:56:24 EST 2012 | rway
Juggalo, Your boss obviously hasn't thought about the implications of taking a complacent attitude toward safety can cost. He is liable if someone gets hurt working in his plant who isn't wearing the proper safety equipment or none at all. It does
Electronics Forum | Fri Jun 14 13:43:02 EDT 2013 | rway
The low value will be 0.624uF. You have to factor it from the low tolerance (-10%). So: 0.9 x 0.92 (machine tolerance) x 0.91 x 0.91 x 0.91 (3 decade aging factor for X7R dielectric). We factor hours at the 3rd decade (10,000 hours), but you can