Electronics Forum: 103 (Page 1 of 9)

KISS 103 Repiar

Electronics Forum | Thu Apr 04 17:12:07 EDT 2024 | ronh22

Or KISS 103 seems to blown on of the Gecko Stepper drives. Anyone have a good way to replace it? There does not seem to be any good access to it. Do I need to remove the complete solder assembly to gain access?

KISS 103 Repiar

Electronics Forum | Thu Apr 04 18:50:30 EDT 2024 | proceng1

Is this a SWACK or MACH machine?

KISS 103 Repiar

Electronics Forum | Thu Apr 04 18:32:06 EDT 2024 | proceng1

You can access the GECKO from the rear service access panel. It's also possible that you blew the fuse for the Gecko and not the gecko itself. Usually when the Gecko goes, the axis works, but it shudders or grinds. If it's totally dead, the fuse is

KISS 103 Repiar

Electronics Forum | Thu Apr 04 18:38:08 EDT 2024 | ronh22

I have the rear panel off and I can see the Drive but there is very little clearance looking down or working. Where are the fuses located? We also had the breaker pop a few times on out main breaker before this happened.

KISS 103 Repiar

Electronics Forum | Thu Apr 04 18:42:19 EDT 2024 | proceng1

Unfortunately, I had 4 machines, and they all had slightly different component layouts. However, the fuses are usually behind the geckos (toward the front of the machine) just on the other side of the wire tracks. Probably a Terminal Black type wit

KISS 103 Repiar

Electronics Forum | Thu Apr 04 19:13:51 EDT 2024 | proceng1

My original GECKOs all had labels marking them [X, Y, Z, SP] I believe the fuses holders did also. I used a mirror on a stick and I took a set of plastic handle precision screw drivers and cut the handles in half in order to be able to work the smal

KISS 103 Repiar

Electronics Forum | Fri Apr 05 11:50:20 EDT 2024 | proceng1

I can tell you that Z motors and Geckos were the items we replaced most often. We had two MACH machines converted to SWAK and didn't have the GECKO issue anymore. But still replaced Z motors and Pump (SP) motors. When I ordered the motors direct,

KISS 103 Selective Solder programming HELP

Electronics Forum | Tue Jul 19 13:57:52 EDT 2022 | proceng1

I emailed you my procedure for that. Did you not get it?

KISS 103 Selective Solder programming HELP

Electronics Forum | Tue Jul 19 15:57:20 EDT 2022 | tpratt

That was exactly the problem, it's working properly now!

KISS 103 Selective Solder programming HELP

Electronics Forum | Tue Jul 19 13:00:44 EDT 2022 | proceng1

I can help with this. Is your machine running MACH software or SWAK? If you want to email me, you can. I am 90% sure I know what the issue is.

  1 2 3 4 5 6 7 8 9 Next

103 searches for Companies, Equipment, Machines, Suppliers & Information

Voidless Reflow Soldering

High Resolution Fast Speed Industrial Cameras.
ISVI High Resolution Fast Speed Industrial Cameras

Nozzles, Feeders, Spare Parts - Siemens, Fuji, Juki, Yamaha, etc...
thru hole soldering and selective soldering needs

High Throughput Reflow Oven


"回流焊炉"