Electronics Forum | Tue Sep 19 12:09:47 EDT 2006 | SWAG
Cleveland Cotton Products 800-321-1050
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Feb 22 19:21:05 EST 2000 | Peter
I like MPM's 500 machine. I purchased the predecessor model when it was made by SMTech. This machine has programmable pin supports which made setting up for double sided boards really easy. For auto alignment, I think only in-line machines have th
Electronics Forum | Thu Nov 03 11:23:40 EST 2005 | JeffP
Jay, What are your board sizes? What is the maximum size that you envision reflowing? 10-50 boards a week . . . is that in a single run or broken down into a few boards a day/hour? Do you have a high mix or is it a single product? Are the boards
Electronics Forum | Wed Apr 15 21:55:45 EDT 2015 | cspasol
Anyone know where can I find SF-820-LF reflow Hood (Electric Actuator cylinder)? Name: Controller Power Supple Input Voltage: 110V-220VAC Output Voltage:24VDC 50VA Type of Daty: 10%-50% We urgently need this part. Thank you for reply.
Electronics Forum | Thu Apr 16 06:06:07 EDT 2015 | cspasol
Yes it is a 24 linear Actuator. Specs that can be seen on the part are: Name: Controller Power Supple Input Voltage: 110V-220VAC Output Voltage:24VDC 50VA Type of Daty: 10%-50% It is a chinese brand. Maybe there could have anyone with same specs
Electronics Forum | Tue Apr 18 08:05:00 EDT 2000 | Wister
Hi, I got an interesting result after completing DOE that more open defects occurred higher the viscosity.The ppm would be 500 while the viscosity is 950 and it would be 1500 while the viscosity is 1050.The range of viscosity is 900 ~ 1100kcps. The p
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Tue Sep 07 21:30:24 EDT 2004 | peter016
I would like to know what are the achievable chip placement per hour for the following chipmounter models. 1. Siemens HS50 (Spec at 50,000 chips per hour) 2. Siemens Siplace S20 3. Fuji CP 642 4. Sanyo TCM1050 5. Universal HSP4975(re-badge of TCM3000
Electronics Forum | Mon Nov 19 21:42:51 EST 2007 | jwsmt
I'll e-mail pics to you. Answers to asumptions: * Flex in end-item use was measured at 410 microstrain * Supplier PPM last 12 mos less than 1 * Part goes through 2 reflow cycles; once on top and once on bottom * ICT microstrain was 1365; reduced to
