Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Thu Dec 07 11:49:28 EST 2006 | K
We currently have RMA and WS soldering processes here and do batch cleaning for both. We are experiencing some capacity issues and are interested in looking at an IN-LINE aqueous wash. My experience with in-line wash is only with WS. 1. Since RMAs
Electronics Forum | Fri Dec 08 10:24:11 EST 2006 | pjc
The Speedline Technologies- Electrovert AquaStorm 200 is one machine that can do the trick. You'll need the Chemical Isolation option for the RMA flux and you'll need a cleaning chemistry like what Zestron and Kyzen have. Yes, hi-density boards with
Electronics Forum | Fri Dec 08 02:40:45 EST 2006 | Mike Konrad
Hi 'K', We manufacture both batch and inline defluxing equipment so we have no axe to grind with either technology. There are pros and cons associated with both technologies under specific conditions. Batch machines are typically good cleaners but
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Mon Aug 12 18:26:05 EDT 2002 | pjc
If you are talking actual placement rate- from first fiducial read of board no. 1 to first fiducial read of board no. 2, here is the best I've ever seen based on the boards I've run: CP3- 141 seconds for 468 components per board (all rectangular chi
Electronics Forum | Tue Mar 12 09:23:35 EDT 2013 | SMT Newbie
I was wondering if people could throw out some recommendations for what they think would be a good choice of machine for placing truely odd form components. Odd form meaning different types of custom shields ranging from rings to arcs. I know that
| 1 |
winsouce.jpg)
.gif)
