Electronics Forum | Fri Feb 22 12:51:42 EST 2008 | fastek
Logan- That's good to know as I've wondered what makes the 0201 feeder from Fuji so different $$$ from an 0402 feeder? In that they are both 8 x 2mm feeders is it simply a different tape leaf that is the difference? And is the high price compared to
Electronics Forum | Wed Apr 23 10:19:53 EDT 2008 | mikesewell
Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've
Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Wed Aug 13 22:23:24 EDT 2008 | davef
8.4 * SAC305 => 7.36 * Sn-3.5Ag => 7.5 * '....in' [96.2Sn-2.5Ag-0.8Cu-0.5Sb] => 7.39 * Sn-4Ag-0.5Cu => 7.39, 7.44 * Sn-3.8Ag-0.7Cu (Multicore solder) => 7.5
Electronics Forum | Fri Sep 05 11:32:31 EDT 2008 | realchunks
I just bought some of XPM3 series. according to Vitronics, you shouldn't go through more than two quarts a year per each oven. Have you experienced this? If not then I too would be interested in a 2nd source.
Electronics Forum | Tue Oct 14 07:22:05 EDT 2008 | ccouture
I use this directly in the solder pot inside the wave machine. It is small enough to float at the surface of the solder, yet by loading it it act as a sieve and retains the dross while most of the solder pass trough, allowing me to clean the whole po
Electronics Forum | Fri Oct 17 04:23:51 EDT 2008 | fujiphil
Check the image using the fast inching [F] and axis selection [2]. After vision error, press [F] then [2]. The monitor will display a binary images. You will now have a visual look on how the error occurs. Adjust the CCD level of the camera until you
Electronics Forum | Thu Oct 23 11:11:46 EDT 2008 | bobpan
Ok, been a long time so dont quote me on this.....but i think you have to go into assembler configuration and change a number that is located under each assembler to its own number....ex....assembler 1 assembler 2 . They probably both have a 1 at t
Electronics Forum | Mon Feb 02 09:22:55 EST 2009 | ck_the_flip
Everyone's telling you setpoints, but yet, we haven't seen a thermal profile from you. It'd help if you can provide this, and using everyone's recommended setpoints, determine if your profile is meeting: 1.)Time Above Liquidus 2.) Peak 3.) Ramp
Electronics Forum | Tue Apr 28 03:05:48 EDT 2009 | nibirta
Hi, we are facing a problem with a cobar solder paste and i need some support here. We have 2 lots of solder paste: one makes solder balls, one no-solder balls. Can you suggest me any analyses that we can performed in order to see the differences bet