Electronics Forum | Thu Oct 23 09:40:31 EDT 2014 | rgduval
Thanks, George. Yep, we got through all of that. Then went to cleaning the nozzle changers, etc. Had a tech in the other day from the broker that we bought the machine from, and discovered that the problem in changer 4 is that we don't have any
Electronics Forum | Tue Oct 21 22:25:35 EDT 2014 | richardciccarone
Thanks for the input. I read that paper. I'm not convinced the Pb stabilizer and bath MTO's are a cause of the Black Tar defect. If that were the case, given the history of Pb stabilizers and ENIG, I would have thought that there would have been many
Electronics Forum | Wed Nov 26 11:53:53 EST 2014 | philc
Reckon on around 2% of wasted parts for each and every component used, and you won't be too far off. Decide on a value below which you don't care, and for parts that cost more than that, you need to keep a closer eye on them to see if they are indee
Electronics Forum | Thu Dec 11 09:15:06 EST 2014 | sreejhu
Hello Sir, Thanks for your reply. i just got a mail from the DIMA service group and they said the Oven setting is as follows: Max temp settings in each zone (Which is not the temperature on your product, but close to where the air flow comes out of
Electronics Forum | Fri Apr 17 12:09:21 EDT 2015 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
Electronics Forum | Sun May 03 04:11:20 EDT 2015 | booth
Hi all, I am looking for a high quality PCB manufacturer who are good at manufacturing 2+N+2,3+N+3 these high complex HDI pcbs. Is there anyone who could suggest me a good PCB manufacturer? I could find a lot of PCB houses in the Internet but I
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Tue Aug 04 12:11:56 EDT 2015 | bnorton
OS/2 UIC version 3.2.3 Powerup seems to go OK until, while the GUI says ...initializing..., an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want t
Electronics Forum | Fri Aug 14 08:41:23 EDT 2015 | emeto
I don't know what paste you are using, but most of the leading brands can stay out of the fridge for up to 6 months.The paste you already took out of the cartridge should last you several days - up to one week, depending on your room temperature and
Electronics Forum | Fri Aug 14 07:52:03 EDT 2015 | mun4o
Hi all, 2 weeks ago we installing a new P&P machine - chip shooter.But , after installation proved that vibration of the new P&P arе very strong.If I use mashine to 100% of the speed the machine vibrating and after 2-3 panels moving 3-5 mm.The machin