Electronics Forum | Thu Nov 10 10:01:15 EST 2005 | Loco
I've been told these machines measure an area of 1 to 2cm�, if so how would you be able to just measure the plating of let's say a regular 0805?
Electronics Forum | Thu Nov 03 10:02:33 EST 2005 | Rob
Very badly in general. You may get away with it if: 1) Your board if very thin & simple 2) Your heaters will actually allow the zones to reach the required temperatures 3) There are no fragile components on board 4) You've been very good & believe
Electronics Forum | Thu Nov 03 12:02:42 EST 2005 | jrr3434
JP We are a CM planing doing a high mix of boards ranging from 2"x4" to 8"x10" in a single run of 10 to 50. We don't plan on doing any double side boards. Jay
Electronics Forum | Tue Nov 08 14:20:39 EST 2005 | OverTheHill
"We have four new MY12's running version 2.4.3i software." New? Call MyData, dumb-ass.
Electronics Forum | Mon Nov 14 12:17:17 EST 2005 | avalancher
You should contact MYDATA service department and see what advise their phone support people can offer. You may not be doing the process correctly (wrong calibration boards, etc...)
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Thu Nov 17 23:33:08 EST 2005 | darby
If the machine is on it's way..... Question is 1. What if the machine is on its way / remote site...and need to estimate (say 90-95%) probability ? A1. 1 x 8 hour shift 65% x 1 of software estimate or stop watch estimate run on same machine in a dr
Electronics Forum | Sat Dec 10 07:03:59 EST 2005 | mdemos1
Hi. I am trying to find out the minimum copper thickness I should see on a through hole barrel. The board has 1 ounce copper and the board thickness is 0.062". I am finding thicknesses of 0.6 to 1.2 mils. Thanks, Mike.
Electronics Forum | Thu Dec 15 08:54:43 EST 2005 | Amol Kane
my 2 cents here --- Even though the boards need not be cleaned after SMT when using no clean flux, you will still have to clean them before conformal coating.....and most solvents used to clean boards before coating will take out the no clean flux re
Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee
Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n
