Electronics Forum | Thu Mar 24 09:33:45 EDT 2011 | bobpan
An old quad 2C/4C with a workholder will probably fit all those numbers. 2Ft is pretty long though and that might be a little too long. Machine price range is about right. Programming is pretty easy. Good luck
Electronics Forum | Mon Jun 27 03:40:44 EDT 2011 | samsim
Other areas you can focus 1) Find out alternative chemical and solder materials for lower cost. 2) Set high power consumption machine (such as Oven and wave) to idle mode when not running to cut electrical consumption. 3) Reduce the used of N2 gas.
Electronics Forum | Sat Jul 09 11:15:48 EDT 2011 | temelyucel
we are looking for ex field engineer for uic gsm1 and gsm2 machines
Electronics Forum | Tue Aug 23 06:59:26 EDT 2011 | headlad
We use a 2 part epoxy from DEVCON it's listed as 5 minute FR 2 part epoxy. We have used a lot of the material with excellent results, specifically for security reasons.
Electronics Forum | Fri Oct 07 09:00:03 EDT 2011 | blnorman
2D codes take up much less real estate so that might work. Something else we did was to go to CO2 lasers and mark directly into the solder mask. Underlying copper gave adequate contrast to the green mask. Much more of an investment, but works grea
Electronics Forum | Mon Nov 07 13:52:10 EST 2011 | leemeyer
Can anyone supply me with the default MOD codes for a Quad 2C. I have recently picked up a used one and am having trouble getting to run properly. All I have is codes for a 4C. Thanks
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Thu May 31 10:25:19 EDT 2012 | edmaya33
J-STD-001E, 8.3.6.2 states 1.56um/cm2 NaCl value.
Electronics Forum | Thu Aug 09 23:18:15 EDT 2012 | dekhead
Depends on to what degree it has been disassembled; How much verification of repeatability is required; and if everything actually works... 2 hour - 2 days.
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no