Electronics Forum | Wed Jul 20 18:08:38 EDT 2005 | russ
How long is it taking to reach the 150? We use the 020 here along with 023 and have very good results with our machine. The 023 is rated for a higher temp then the 020 but I don't know about staying power. We heat from both the bottom and the top
Electronics Forum | Tue Aug 02 22:44:42 EDT 2005 | crishan
Thanks for the comments everyone. I did not think of checking the nozzles material, I will check this out. GS, What is PBM, is this some sort of ironiser. Also to clarify, we believe the that the pocket size for the component is too big allowing th
Electronics Forum | Mon Mar 06 10:59:42 EST 2006 | ezamborsky
Sorry to hear of your problems with your VPI-1000. As most people know the VPI line was transfered over to the Easy Braid Company last July. With most changes of this type there can be some initial confusion and and unneccessary stress placed on endu
Electronics Forum | Thu Aug 11 03:56:11 EDT 2005 | md
Guys, I have a 2.4mm pcb 8layer with a lot of copper on board. I am having some problems with solder not travelling up through the holes. Looking from the bottom of the board it looks fine . Also, To measure temp. of board through preheat zones
Electronics Forum | Tue Aug 16 11:27:14 EDT 2005 | saragorcos
Hi Peter, I posted these links to Technet as well, but figured I would add them here as well in case any of the smtnet readers would like to see them. Here are some links to some articles about white residue sources, and whether or not white residue
Electronics Forum | Thu Aug 25 08:54:24 EDT 2005 | stepheniii
Could it be cold solder? Are there parts nearby that might be soaking up lots of heat, or maybe lots of internal grounding near that corner? Once I saw something similar except it was on two different assemblies. Each time it was on the side of the
Electronics Forum | Wed Aug 24 21:57:45 EDT 2005 | adeline_ko
The blistering is around the plugging via. I can forward you the pic. For the plugging process, I'm not too sure how they plug. What is the correct practise for the plugging via. Now, what they did is. They will do a tenting process for both side.
Electronics Forum | Tue Aug 23 14:23:00 EDT 2005 | pjc
Most ovens I know use oil to lubricate conveyor chain, not grease. Anyway, is this what you're using: NMG No Melt Grease NLGI 2 (operates from -20�C to +270�C) NMG is a long-fibred highly adhesive grease which does not melt or drip at high temperat
Electronics Forum | Wed Aug 24 22:53:34 EDT 2005 | mrduckmann2000
We have a customer that is using the new Hirose connector p/n df30fc-40dp-0.4v. The connector has lead spacing of .4mm. I beleive that if I have a stencil cut to 2-3 mil I should have enough solder paste to solder the connector to the PCB pads. Ho
Electronics Forum | Thu Aug 25 15:55:11 EDT 2005 | pjc
I believe you'll need to have fume extractors for wave and oven to clean the exhaust: http://www.solderfume.co.uk/index.html http://www.allerair.com/air-purifiers/candi.html http://www.impell.com/main/index.cfm I believe its state regulated as fa