Electronics Forum | Mon Aug 29 13:43:58 EDT 2011 | jax
Enlarging the "End Pads" is normally done to help accomodate the Wave soldering process... works as solder thief to help eliminate bridging on the last 2 pins to cross the wave. It is reasonable to assume that, if you are seeing cold solder due to fl
Electronics Forum | Mon Aug 29 16:21:20 EDT 2011 | rjlasko
Greetings...I have a customer that has an assembly that is conformal coated with Humiseal 1A33. This assembly has some components (resistors and FET's) that heated up during operation and has discolored the conformal coating around their location.
Electronics Forum | Tue Aug 30 22:39:29 EDT 2011 | comatose
I'm looking at used reflow ovens. I'm homing in on Vitronics. We're pretty self-sufficient in terms of keeping machines going, but does anyone have experience with parts and documentation support for Vitronics? Is there a fee for getting into the sys
Electronics Forum | Wed Aug 31 14:32:12 EDT 2011 | cbeneat
We run 3 XPM2's. All were new so under warranty, but I've found the support to be excellent over the years. They have moved their operation to MO recently, time will tell if this is an issue. The only maintenance issue I've run into is on our oldest
Electronics Forum | Thu Sep 08 18:01:22 EDT 2011 | comatose
We had a camera die on one of our GSMs. I got a new camera, and it is working, but I need to either find a cal kit to rent for a day, or else if someone knows a reasonably accurate procedure to calibrate the new camera using the other upward looking
Electronics Forum | Mon Sep 12 05:43:53 EDT 2011 | aungthura
Hi All We have run the Hast Burn-in-Board into 2 soldering Process,first-Reflow and second-Wave. After wave soldering, there are many insufficient solder in the via holes.The via holes are wide as 15mil. Then, as customer's request, we have to cover
Electronics Forum | Mon Oct 10 15:21:28 EDT 2011 | spitkis2
In my opinion, YesTech or any other company is not obligated to spend days or even hours on the phone with a 2nd hand end user. If it takes days (paying customer or not) they need someone from the manufacturer to be on the shop floor. YesTech c
Electronics Forum | Mon Oct 03 16:02:55 EDT 2011 | artposada
The machine does not have pre-heating feature. I'm soldering a six-up panel...I've tried putting them a an oven and letting them soak for 20 mins or so at a low temp. But by the time I placed the panel in the machine and manually fluxed the top sid
Electronics Forum | Sat Oct 22 09:02:46 EDT 2011 | mojomatt
Yes it is used for PCB, I have used it in the Automotive Service Industry for many uses. Most popular as a Brake assembly cleaning agent. It is popular today due to its low FLASH POINT, unlike other solvents that contain Heptane, Xylene etc thease ha
Electronics Forum | Tue Oct 18 17:54:53 EDT 2011 | swag
Yea, it's tough and takes 25 disks. Not sure if there's a better way. As for NT, we bought NT upgrade packages from Speedline for all three of our AP25's. The backup is then done on a CD burner. I can't remember the cost of it all. However, be a