Electronics Forum | Tue May 23 20:44:13 EDT 2000 | Dave F
Sal: You and Wolfgang are spot on, but let's see if we can blow this out a bit. Before proceding to rattle on ... � PC Card. A credit card-size computer peripheral that add memory, mass storage, and I/O capabilities to computers in a rugged, compa
Electronics Forum | Tue May 09 17:17:17 EDT 2000 | Earl Moon
Armin, Wolfey, Dave, Jeff, and some others I remember well who have moved on too (way too many to count but all left unfufilled here), I am back. No, just kidding. I still look in from time to time. All of you on the forum are great. I simply decide
Electronics Forum | Sat May 06 08:46:46 EDT 2000 | Dave F
Sal: Now you�re talkin�, buddy!!! Darrell is correct. All things being equal, thermal relieved vias (and through holes) should be the hottest spot on the board at reflow temperatures. Vias are gonna take on solder like drippin�s take to biscuits.
Electronics Forum | Wed May 03 20:04:21 EDT 2000 | Dave F
Joe: Hey, just hose everyone down with water when your humidity starts to decrease to below 40%. ;-) Actually, that�s how some humidity controllers work, when added to your heating system. Well basically that�s how they work. I�m not tryin� to
Electronics Forum | Fri Apr 07 17:17:55 EDT 2000 | Dave F
Ashok: You should select and use low residue tapes. But ya know, ya go out and research a great tape and if yer not careful, the buyer will second source ya and (surprise) ya got residues again. We have found that Lemme say this about Katon tape
Electronics Forum | Fri Mar 10 15:47:35 EST 2000 | Casey Scheu
Russ, As I stated earlier 100% satisfaction guaranteed. I'd like to address a couple of your problems. 1. Lack of TC control. I don't really understand this issue. The system is a closed loop system w/ the TC located directly in the nozzle block.
Electronics Forum | Wed Feb 16 21:51:29 EST 2000 | Dave F
Kurt: Lots of choices, not many of them good, yano. 1 So LPI has taken over the market pretty nearly 100%, but it won't "tent" reliably, because it is not very viscous when applied and drops into the hole. So then, tenting/plugging with LPI is bad
Electronics Forum | Thu Apr 19 15:22:34 EDT 2001 | jdtpfacreate
Spanky, It sounds like you are looking for a recipe to use when you do get an assembly in that has 0201's on it. We have worked with our customers worldwide in the development of the process to use 0201's. Most equipment manufacturers out there
Electronics Forum | Mon Nov 27 12:13:39 EST 2000 | rabell
Dave, this is a massive question, and if you have any hard data on these issues, it would be wonderful if you could share it. The best I can offer is some indication of our experiences from contacts in the industry. Keep in mind as well, that we ha
Electronics Forum | Thu Jun 22 14:57:34 EDT 2000 | Lee
Mike, when you ask if companies afford to place additional environmental constraints on the manufacturing process, perhaps we should ask whether they can afford not to pay attention to environmental issues. I know this sounds a little flippant, but i
