Electronics Forum | Thu Jul 18 09:31:11 EDT 2002 | Mark S.
As part of our Efficiency Improvement Plan I have been tasked at determining the Key Production Indicators from available production data. So I thought I would ask others what they thought were 1) the top production indicators for their facilites 2)
Electronics Forum | Thu Jul 18 12:36:28 EDT 2002 | dragonslayr
would appreciate any help for a reference to a maintenance engineer/ programmer to help us revive KME CM 82-C LE, May 1993. apparently the computer has lost the main program. We are located in Fremont, CA. Thanks in advance for any help. yeah, yeah,
Electronics Forum | Thu Jul 18 14:34:48 EDT 2002 | Kenny
I am looking for advise on making(soldering) and ensuring of a quality solder joint. We are doing the process by hand and are soldering wires onto PC boards and transducers. Looking for any suggestions that may help in either; overall ways of making
Electronics Forum | Sat Jul 20 09:02:04 EDT 2002 | davef
Probably 2) what is this white residue material (chemically )? => Natural or synthetic rosin 3) Can Saponifier wash, helps? If not what is the best solution to remedy this white residue. => Probably a saponifier will work. Some NC flux residues
Electronics Forum | Mon Jul 22 09:51:06 EDT 2002 | pjc
They have the part because they're selling the part. UIC's Replacement Parts Division doesn't care about when a machine was built. All they're concerned about is what parts are selling. That old part I'll bet was for an axial VCD inserter or sequence
Electronics Forum | Mon Jul 22 11:41:11 EDT 2002 | Claude_Couture
The trick is to put a serial number on each feeder and use a maintenance tracking software. There are commercial software out there that do just that. Some even use the barcodes to track the location of the feeders, so you know which machine it is on
Electronics Forum | Tue Jul 23 05:41:13 EDT 2002 | kumarraju
first you need to have bar code stickers put on to your feeders.You need a tracking software to track your feeders using the bar code.you need to do periodic maintenance on your feeders and very important is calibrations.it is best to set up a feeder
Electronics Forum | Mon Jul 22 11:51:28 EDT 2002 | philclegg
Has anyone had experience using Copper Passivate coated PWB's, our supplier calls them "flux coated" but as it's an Organic finish is it handled the same as Entek and where can I get details about it?. I have used Entek CU56 & Entek Plus coated PWB's
Electronics Forum | Mon Jul 22 12:44:49 EDT 2002 | krs
Hi Does anyone know of any studies carried out comparing long term reliability of BGAs with their equivalent QFPs etc. If you were designing a critical product in the aerospace field would you go for the BGA or QFP version of the same IC? Based on
Electronics Forum | Tue Jul 23 12:54:07 EDT 2002 | krs
Dave Thanks, some very interesting articles on that link, it really is rocket science! However this article is a bit of a tease, it tells you how they compared different package types, CBGAs and PBGAs and a fine pitch QFP but does not detail the