Electronics Forum | Thu Nov 06 09:05:14 EST 2003 | russ
Add some orange juice! Seriously, with a high PH adding almost any form of acidic soluble material will bring it down Russ
Electronics Forum | Fri Nov 07 08:12:24 EST 2003 | caldon
From my understanding (and I am not a metalurgist)Most Lead free solders can be intercahngeable.The alloy created should be stable. The issue is if you add Leaded solder to the joint. Obviously, research and testing is still pending. cal
Electronics Forum | Thu Nov 06 13:44:15 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Thu Nov 06 13:44:18 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Sat Nov 08 08:16:45 EST 2003 | davef
We saw this quite a bit, I want to say 5 or 6 years ago, but it's probably more like 10 years ago. It's caused by poor solder mask crue. Talk to your board fabricator about solutions.
Electronics Forum | Fri Nov 07 12:57:36 EST 2003 | microwave
Hi, Help :( I need manuals and instructions for Panasert MK I Model No NM-2562 Prod.No KAAA-629 Ser.No 80800155
Electronics Forum | Fri Nov 07 18:26:05 EST 2003 | jsloot
Is anyone using .062 aluminum circuit boards with copper conductors in your production lines? What kind of reflow profile is required? What special considerations are there to be looking for? I am asking for any information you can give me. Thanks
Electronics Forum | Wed Nov 12 20:03:49 EST 2003 | davef
We used to do this kind of stuff in vapor, but do none now [although the imagination doesn�t have to turn too much to envision doing it again]. Start here: * http://www.bergquistcompany.com * http://www.gouldelectronics.com
Electronics Forum | Tue Nov 11 04:48:48 EST 2003 | Dmitry
What kind of equipment is used to insert LEDs into PCB? LEDs are in tape form. Thank you for your help!
Electronics Forum | Fri Nov 21 13:14:21 EST 2003 | pjc
Panasonic is another supplier of automatic radial lead insertion machines. Go to: http://www.panasonicfa.com/cgi-bin/product.cgi?prodline=electronics%20assembly&category=Pin%20Through-Hole∏id=rh5 www.panasonicfa.com