Electronics Forum | Thu Jun 12 13:01:08 EDT 2003 | ServGuy
Yeah, what Techsuppguy said. But further there are a few more points. The first is in the current market situation far less new machine are being purchased and far more are just changing hands. In the past the ratio of warranty machine service pho
Electronics Forum | Thu Jun 12 14:34:50 EDT 2003 | Steve
Varied opinions on this thread spread faster than wild-fire. First, I must say that analogies to auto dealers are a bit flawed. Business to Consumer is one thing. Business to Business is a completely different ballgame . . . no sense of comparing t
Electronics Forum | Thu Jun 12 14:49:33 EDT 2003 | bubbacott
Jason I am an equipment buyer part of my job is to be knowlegable in every make and model we look at, registration is a calculable cost going in before penny one is spent many brokers and oem's know who I am and I will rage about registration, howeve
Electronics Forum | Fri Jun 13 22:04:47 EDT 2003 | iman
I would say, if one guy buys used machine from a "dealer", the dealer ought to cover the registration fee up-front for the buyer as part of a complete package, UNLESS the buyer himself/herself asked for a discount that purposefully omitted the requi
Electronics Forum | Thu Jun 12 11:12:08 EDT 2003 | babe
The last statement saying that seeing down the bga component with these systems is useless, is an incorrect statement. First with x-ray you do not see flux residue and or flux migration, second with x-ray you do not see a cold solder joint. Visual i
Electronics Forum | Thu Jun 26 04:34:49 EDT 2003 | emeto
Hi James, I saw very good posts here.Now I will give you one more practical way: 1. My advice is to encrease the temperature(like your first sidgestion). Termostress is important thing so your first zone should be 120-150C. 2. The paste profile. If
Electronics Forum | Tue Jun 17 01:27:25 EDT 2003 | Dreamsniper
Hi Guys, I need your opinion here. Has anyone tried doing this Process: Bottomside Process first which means gluing the chip components then reflowing the Glue instead of Curing them, then Topside process which is solder paste printing then compone
Electronics Forum | Tue Jun 17 15:52:51 EDT 2003 | russ
Is this a single sided or double sided board? We run the first side flat on the oven belt this keeps the board flat for the second side assembly. If the board warps during the second reflow process we will make a support fixture to carry the PCBA
Electronics Forum | Wed Jun 18 10:07:02 EDT 2003 | caldon
There are a few directions to go from Here... 1) Outsource it to a CM, 2) Capital investment both have there issues. To Out source I would have processes in place to Inspect quality, resolve issues, Assure quaility, and Hope they can meet your deadli
Electronics Forum | Tue Jun 24 17:41:29 EDT 2003 | MikeF
I'm looking for an esd safe tray, something like what pharmacists use, that we can use to count out loose parts. Has anyone seen something like that? We have a lot of part values in our stock room that have maybe 100 or so loose parts in a bag. The
