Electronics Forum | Thu Apr 20 14:24:54 EDT 2006 | pms
Sr.Tech, Don't know about AP25's, we have a DEK. We have problems with some large board sagging in the middle, causing the board to slip under the board stop, but our DEK has the ability to program the board stop anywhere in the Y direction, allowin
Electronics Forum | Thu Apr 20 14:33:18 EDT 2006 | dirk29
We had that problem with our printers we just drill and tap the top end of the stop and put a short screw in to allow us to adjust the top height of the stop and catch the board. Be careful not to make it to long or to could restrict the board from l
Electronics Forum | Thu Apr 20 16:40:33 EDT 2006 | PWH
All our AP's have camera mounted board stop sensors (works like a conveyor sensor). You can also mount these sensors on or near the conveyor if you want. We do not have problems like you talk about. You should call MpM and ask them if it's possibl
Electronics Forum | Fri Apr 21 13:28:51 EDT 2006 | cyber_wolf
Chunks, I know about the board stopper in the camera. I forgot to mention that our 1 AP25 is a HI-E machine with that camera in it. The HI-E still uses the dedicated tooling. When the snuggers engage the board pops over the mechanical stop. We do
Electronics Forum | Mon Apr 24 13:23:37 EDT 2006 | pjc
Use the photo sensor to stop boards instead of the hard-stop. There is also an ultrasonic sensor upgrade. A little more robust than optical. Y Snugger Tooling upgrade is kind of pricey and they like to do that in the plant. But, I've known that upgr
Electronics Forum | Tue May 02 18:08:32 EDT 2006 | Nirmal
are u using 3d / 2d camera 1) machine setup support pin must be strong. 2) machine part libary must be perfect and good condition. 3) using the right nozzle. 4) check the board clamp must be clamp fully. 5) and we can also try doit head and camera
Electronics Forum | Thu Apr 20 22:14:51 EDT 2006 | raquel
hello! need ur inputs... if the Matte Sn pbfree finish of the component discolors AFTER having been exposed to bake, or, after reflow, will the base leadframe have any potential contribution to it? i know most likely suspects would be the plating pro
Electronics Forum | Fri Apr 21 07:56:18 EDT 2006 | Steve
I bought an ultrasonic cleaner from the states and thought it would run with the usual travel adapter. So, I have obviously run 240v through a 110v unit. Something inside went pop and it hasnt worked since. Does anyone know which component on the cir
Electronics Forum | Fri Apr 21 09:15:03 EDT 2006 | russ
I would recommend that you find a small 3-4 zone oven with convection preferably. If you are running lead free then you will want to find at least a 5 zone. With lead free coming on, there are many small ovens available from companies upgrading.
Electronics Forum | Wed Apr 26 11:46:34 EDT 2006 | Dr. Timothy J. Harpster
I have spoken to the people at Manncorp and was not impressed. Their units are significantly cheaper than some other comparables on the market but from my conversation with them I am sure there is a reason for the reduced cost. We have decided to go