Electronics Forum | Fri Feb 17 16:57:33 EST 2006 | Hoss
I'm looking for an RH meter for monitoring of a component drybox. Our target is to maintain 0-1% RH. I've looked at many different units and none of them have the required accuracy. +/-2% is the best I've been able to find with units capable of me
Electronics Forum | Mon Feb 20 16:31:09 EST 2006 | GS
Hello Gents, ..............several questions about the subject: Q1)Are there any standard regulating the subject ? Very few infos found on IPC. Q2)Which materials are suggested to seal (Bag) the PCB ? Q3)Is it necessary the vacuum sealed bag ? if
Electronics Forum | Tue Feb 21 09:19:50 EST 2006 | Chunks
Hi Mark, Not to be condescending, but is your 265 camera in focus? I've seen one instance of this. If it�s not the camera, and you are sure all your other parameters are good, , then poor definition can be from bad snap-off or bad gasketing. Snap
Electronics Forum | Tue Feb 21 13:49:59 EST 2006 | slthomas
So am I. Have been for about 3 years. Metcal won't make the custom nozzles any more so even the cost ineffective route is closed. What's funny is that they make an adaptor to fit the FCR nozzles onto the QX2 but won't make one to fit the QX2 nozzles
Electronics Forum | Fri Mar 03 20:45:58 EST 2006 | KEN
I have used KIC data acquisition equipment for over 11 years. Slim kic, sideKic and Kic2000, prophet etc... The 9 volt battry changes in seconds. Gimme a break. The internals don't reach 54Celsius. If it came down to batteries, I bet KIC would t
Electronics Forum | Sat Mar 04 03:39:57 EST 2006 | grantp
Hi, I agree, we have a KIC and have run hundreds of profiles and are still running the original battery and have never had a problem. The software is what matters with profilers I think, and the KIC has really good software that shows you a process
Electronics Forum | Wed Feb 22 09:48:24 EST 2006 | slaine
Hi Ive checked into this a bit more, there are two coatings im told you can get one is a teflon coating that you paint on then bake, the other is a red oxide (lead free) paint. Also if your using solder pots and they are close grain cast iron they a
Electronics Forum | Tue Feb 21 20:22:46 EST 2006 | mnguyen
Hi, I am having problem looking through IPC and finding according to ISO spec what should the paste height requirement vs stencil. EXAMPLE: The stencil is 5mils thick and according to the specs we have on paste height measurement the max height to be
Electronics Forum | Wed Feb 22 12:19:49 EST 2006 | Dirka Jihabi
I worked for a EMS who makes Medical Device Electronics, and yeah, the FDA's methodology for validation is a complete cluster-fudge! They did it on the principle of...does the shop air going into your equipment REALLY 80 PSI...or is there REALLY 220
Electronics Forum | Thu Feb 23 08:06:03 EST 2006 | davef
"The three dispensing pumps used for encapsulation are the air/time syringe, rotary positive displacement pump (RPDP) and the linear piston pump. Each of these methods of dispensing offer different attributes but the most accurate method is the linea