Electronics Forum | Wed May 02 23:52:12 EDT 2007 | paligora
After a battery backup failure, I have lost the software from a PCB unloader. This is a Tamura brand magazine unloader using an omron PLC. I'm not sure this forum accepts pictures. I am told that if I can find someone with the same hardware and so
Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Sat May 05 11:57:52 EDT 2007 | mohdfazuwan
i'm looking for BGA Rework Station - Temp Profiler for ERSA. Rit now i facing problem the Temp profile easy to drift from initial setting. Hope some one can advise me what type of Temp Profiler suitable for Ersa BGA Rework station. Hope the profiler
Electronics Forum | Sat May 05 17:46:42 EDT 2007 | bkgsmtnet
I need suggestions for Quoting software for a contract electronics manufacturing service. I want something detailed if possible that allows breaking down every step involved and multiple labor rates depending on the task being performed....I would al
Electronics Forum | Mon May 07 10:27:40 EDT 2007 | colormaker
The spray bottle puts more flux on the board but I am not sure how to measure ? I just got the Novastar 12S and its very difficult to set up. When I fix one problem another one show up. When I do get good results I dont make changes and then after a
Electronics Forum | Mon May 07 11:08:13 EDT 2007 | gregoryyork
Are the pallets hot and killing the foam head as they pass over or is the air pressure on the air knife toi high travelling back along the board killing the foam. If these are OK make sure you have sufficient back flow onthe wave and you are draining
Electronics Forum | Mon May 07 12:11:33 EDT 2007 | colormaker
I have the option of increasing the wave pump but when I do the wave is very unstable. Do you have the possibility to create a backflow at the wave to drain the oxides away from the board? Not sure how to do this I wish I have the old 1962 7' holl
Electronics Forum | Mon May 07 12:40:08 EDT 2007 | patrickbruneel
Jerry, At the end of the article in the link you will see how the wave needs to look like. http://www.interfluxusa.com/Technical/No-Residue_implementation.htm This wave design has been adopted by most machine manufacturers and I would be surprised
Electronics Forum | Fri May 11 17:19:21 EDT 2007 | colormaker
Authough your response is harsh I tend to agree with you. I bought it used and was told by others at the time its a workable machine. Any suggestions on a machine for 40 boards an hour ? I run 400 boards a week and like to run the solder wave on wee
Electronics Forum | Thu May 17 09:00:51 EDT 2007 | bsteffen
Since your budget is between 25 and 30K I would say you have plenty of options. Electrovert and Vitronics are both good solid machines. Seho is another option. Seho is extremely user frendly and maintenance freindly and easy to profile however, it is
