Electronics Forum | Tue Jul 24 08:44:17 EDT 2007 | rgduval
Ron, I'd agree that that sounds high. Some things that may be contributing to it: Volume. lower build quantity often leads to higher placement costs. NRE. Does this website quote an NRE for solder stencils, machine programming, and reflow profili
Electronics Forum | Tue Jul 17 11:15:05 EDT 2007 | allgood
We keep seeing a problem with the plastic tool tip on an A12 tool being sliced off. I think it is hitting the edge of the tape separator clip assembly - I determined this by coating the tip in paint and then finding where the tip had struck the meta
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Fri Jul 20 05:09:42 EDT 2007 | allgood
Yes that sounds worth a look - thanks. I am also wondering if there is a thermal issue - we had 27 degrees in here yesterday and I remember the Mydata guy telling me to put a desk fan onto the card frame in the summer. I did this last year - when I
Electronics Forum | Mon Jul 23 11:06:43 EDT 2007 | gmoritz
Steve Thomas: Thank you for the well-written, helpful explanations. Fastek: You must be an accountant. Your advice was totally correct, but of absolutely no use whatsoever. Why even post it? I was basically told; Suprise! You are in charge of o
Electronics Forum | Mon Jul 23 12:31:03 EDT 2007 | gmoritz
Have you tried running it in step mode? Yes, and more. The installer asked me to run a few tests: 1> Intentionally make the machine miss insert a part then put a part in manually to see how the leads align to the cutter head. 2> Push the re
Electronics Forum | Mon Aug 06 11:58:48 EDT 2007 | gmoritz
Do you have BEC (Board Error Correction) > on that machine, and if so, did they > give you the alignment plate for it? I don't know if we have BEC on the machine. I can't even search the 550 page manual that was finally sent to us in a pdf file
Electronics Forum | Mon Aug 06 14:05:02 EDT 2007 | slthomas
BEC hardware would be on the machine as a sensor underneath the placement table, to the left of the C&C, and an emitter attached to a bracket to the left of the insert head. The two line up with each other and the sensor uses a quadrant layout to det
Electronics Forum | Tue Jul 24 07:15:16 EDT 2007 | james
We are currently have failures on one of our QFN components. We are running this product with lead free paste, lead free boards and lead free parts. They have done a pull test on this component and it showed that the solder joint mainly dissconnect
Electronics Forum | Fri Jul 27 08:49:35 EDT 2007 | cman
We are currently have failures on one of our QFN > components. We are running this product with > lead free paste, lead free boards and lead free > parts. They have done a pull test on this > component and it showed that the solder joint > mai