Electronics Forum | Sat Mar 03 13:33:22 EST 2007 | grantp
Hi, I have experience with both MYDATA and Fuji, and I agree totally, you have a MUCH better machine in the Fuji's than MYDATA machines. I had to sell off my MYDATA machines and I put in XP based machines. I just added another 143 to the line, and
Electronics Forum | Mon Mar 12 14:19:16 EDT 2007 | Grant
no offense Grant--I was designing P & P equipment and vehemently studying > competition when your mother was still wiping your nose...I was just ? >responding to the previous comment about footprint and feeder capacity--for > which there is no equal
Electronics Forum | Mon Mar 12 17:17:10 EDT 2007 | gregp
Grant, This is the last thing I will say in this thread. I truly try in all of my responses to add information regarding the original post or a subsequent question in the thread. If the information is about my product it sends guys like you off the
Electronics Forum | Wed Mar 14 09:44:06 EDT 2007 | Cmiller
We use cartridges, that way nobody can mix back in paste off the stencil and no air can get in period. Any paste that is still good to use when removed from a stencil at the end of a job is put into a small pink zip-lock baggy with the date written o
Electronics Forum | Thu Mar 08 08:03:16 EST 2007 | ck_the_flip
ENig can vary in quality, but I've never seen an ENiG board that's been downright unsolderable. At a CM where I worked, I had to prove a QE wrong. He was flippin' out (*no offense*) about black pad, something commonly seen on ENig boards, so what I
Electronics Forum | Thu Mar 15 10:11:27 EDT 2007 | cecil
Just finished using my first Invar stencil. Gotta say I was very reluctant at first but my stencil vendor convinced me to give it a shot. I have to admit that I am pretty impressed. I would have normally used an electroformed stencil for the prototy
Electronics Forum | Tue Mar 06 15:59:33 EST 2007 | pima
hello I would like to ask you for advise. I have problem with one of my SMT line and skewed parts at the end of line after reflow. My line is composed: DEK, 3d visual inspection of paste printing, IP3, 8 zones reflow oven. I m builidng there produc
Electronics Forum | Fri Mar 09 18:32:29 EST 2007 | siverts
We have seen this issue with our RoHS process also. If that is the case and I if understand you correctlcy; then the advice from KSimpson, Stephen, DaveF + "all others" is totally correct!! We have been under this problem a numeruos numbers from time
Electronics Forum | Sat Mar 10 08:05:09 EST 2007 | davef
Here's your test definitions [clipped from the dictionary in the fine SMTnet Library]: * Test, Automated. Computer controlled electrical testing of parts, assemblies, or finished products. * Test, Built-In (BIT). An electrical testing technique whi
Electronics Forum | Mon Mar 12 08:24:30 EDT 2007 | rgduval
ICT is generally a manufacturing verification test. Coverages vary depending on the board. I've run lots with as low as 25% coverage on the board (but produced 98% FPY post board assembly). Functional test is exactly what it sounds like. Checking
