Electronics Forum | Sat Oct 17 18:43:56 EDT 2009 | emanuel
Just a moment.... when the machine was installed I was told to use a dry air line, so it is connected to a line that passes through an air dryer and no oiling at all. Should it have oiler installed? I will check the installation manuals
Electronics Forum | Sat Oct 17 22:04:39 EDT 2009 | isd_jwendell
Oil will make them act faster/smoother, but will collect dirt and dust faster. I prefer to oil, and clean more often.
Electronics Forum | Sun Oct 18 17:34:40 EDT 2009 | emanuel
The main question is, where is the problem: With the piston, in which case I can use some air oil on the rod or even a small drop in the air tube. OR With the mechanics, specifically the sprocket in which case I am not sure oiling only without prior
Electronics Forum | Sun Oct 18 11:48:50 EDT 2009 | Rul
Problems found are the machine frequent freeze suddenly and produce error message when homing the machine: servo devices failed ... Action taken. Change the pc with another working machine. result= same problem happen. check the fuse at circuit of t
Electronics Forum | Mon Oct 19 09:06:13 EDT 2009 | vala
Hi! I would like to read some experience about the reject rate. We have a Siplace X4 and we mesaure week to week this date. Please write me something for this your experience.
Electronics Forum | Tue Oct 20 08:58:27 EDT 2009 | soudomphong
m/c error 3564 raceway monitoring triggered-gantry 3. In the help menu it says topic does not existed. Anybody has any idea what this error code mean? This is siemens hs60.
Electronics Forum | Tue Oct 20 12:30:19 EDT 2009 | soudomphong
Thank you very much for your information, well said. As of right now I am not using this gantry until I can resolve this issue in a timely manner to prevent it from costly repair. Thanks again for the info.
Electronics Forum | Thu Oct 22 14:34:53 EDT 2009 | davef
To find suggestions like: "Go 1:1 on leads and 50% reduction on the body pad. Works every time no matter what QFN," search the fine SMTnet Archives.
Electronics Forum | Fri Oct 23 16:54:02 EDT 2009 | pnguyvu
FOR YOUR NEXT RUN CONTACT STEVE @ USA STENCILS INC, HE WILL MAKE ONE SAMPLE FOR YOU - THEIR TEAM HAVE SOLID EXPERIENCE IN STENCIL DESIGN ESPECIALLY PCB WITH CRITICAL COMPONENT. HIS EMAIL IS STEVE@USASTENCILS.COM GOOD LUCK!
Electronics Forum | Fri Oct 23 17:33:42 EDT 2009 | grizzy
Check that you are following the moisture sensitivity requirements for the part. I've seen the part swell underneath. You can contact me at wenroth@reconsales.com for more information. I am an 'ol reflow guy from the CM world. Wes
