Electronics Forum | Fri Sep 17 01:19:02 EDT 2010 | sachu_70
I suggest you have a look at the method and detergents used during cleaning / washing these smocks. This would help to understand if the smock properties deteriorated on account of such process. In addition, you could keep one unused sample for over
Electronics Forum | Mon Sep 20 00:47:35 EDT 2010 | emmanueldavid
AL, Let's always remember that any Temperature controlled environment has to draw higher Time to bring the Temperature down than that is drawing for Temperature Ramp up. The best way is to keep Room Temperature in as low as possible level & open t
Electronics Forum | Sat Sep 18 06:23:39 EDT 2010 | bandu_shende
We are d2h pcb manufactures. We are having using ST BGA Ics un our pcbs. Can u please confirm how many will be the standard BGA rejection including parts,process etc.For example there must be 1 defect in thousand of two defects in thousand.What is th
Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr
This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on
Electronics Forum | Mon Sep 20 06:29:27 EDT 2010 | darrenleebs
i have an old contact 3av pick and place machine that has started to display placement head position errors. the machine seems to start working if you switch it on and leave it for a couple of hours to warm up. has anybody had simillar issues with th
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Tue Sep 21 08:44:08 EDT 2010 | fnorradd
Hi Guys, Quick question, does anyone know of any companies that referbish wave solder pallets. Ours are a little worse for wear, I know of BLT re impregnating the pallets, but can say that the pallet we tested the process on didn't look promising.
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi
Electronics Forum | Fri Sep 24 14:15:58 EDT 2010 | emrtech
we have been doing reflow on SLX PCBs and found out that when lidding, the components have been shifting. Has anyone been doing low temp lidding on SLX PCBs using the flowstar 4036 soldering system? If so, what low temp solder was used and profile
