Electronics Forum | Wed Jul 17 06:54:17 EDT 2013 | deanm
We manufacture according to military Class 3 standards and we do not vacuum seal any MSD devices. Your current method of dry packing is sufficient as well as dry cabinet or nitrogen storage. A light evacuation of air during the dry packing process
Electronics Forum | Thu Jul 18 05:05:34 EDT 2013 | bobpan
Make sure that the lens is clean and you dont have any parts down inside on the camera. Also sometimes the leds that shine up to the part are bent in crazy directions. Make sure they look like they are all aimed up at the same direction. Is the brigh
Electronics Forum | Tue Jul 16 19:46:36 EDT 2013 | tuxd3v
Hi, I have never done a pcb route for SPI or I2c, I need communication lines for SPI @10Mhz and I2c@1Mhz. I don't know what steps I have to follow to make this communication Lines. Does I Need to look to this lines like "Trasmission Lines", becaus
Electronics Forum | Thu Jul 18 12:02:25 EDT 2013 | emeto
Hi, we have a Dage from Cookson. It is 3D and it gives you good idea about the joints on the board. However, it is not a real automated system. You can create some step and repeat procedures but you should manually confirm defects all the time - I w
Electronics Forum | Mon Jul 29 08:34:40 EDT 2013 | gallionc
I don't see an issue. As was mentioned before, it is what the customer wants. You could approach this from one of two ways. You could simply install the parts, clinch the leads on the opposite side for added mechanical strength and solder the parts
Electronics Forum | Fri Jul 19 06:52:34 EDT 2013 | deanm
A Quad QSV-1 can do up to 18x24in. You can get these on the used market or buy a completely refurbished (like new) machine from Precision Placement Machines (PPM). I do not represent this company or am in any way affiliated with them, although they d
Electronics Forum | Thu Jul 18 18:32:18 EDT 2013 | rway
Hello all, I was wondering who out there has an F1 or F1-5 system used at post-paste. If so, what type of auto-insertion equipment are you using on that line and what is the cph placement capability. Does your F1 system keep up with the cycle time
Electronics Forum | Fri Jul 19 10:01:30 EDT 2013 | dontfeedphils
In a past life I ran F1 systems post placement / pre reflow behind a MyData My12E, so it didn't exactly have to keep up with a speedy chip shooter, but it did pretty well. The AOI would end up being the bottle neck some of the time, but not because
Electronics Forum | Fri Jul 19 12:26:30 EDT 2013 | dontfeedphils
I think right now there is a comfortable buffer built into our process. If our pnp were 50% faster I believe that buffer would be cut out of the equation, so while I think it would be fine on most of our builds, I believe there would be builds that
Electronics Forum | Mon Jul 22 04:59:01 EDT 2013 | bobpan
You have 1 of 2 problems. 1. The encoder is losing steps so it has a problem or the glass scale that it reads has something wrong with it....dirt,cracked,etc..... 2. The downward camera is loose or has a problem. With power on move the head to a posi