Electronics Forum | Mon May 06 09:01:08 EDT 2013 | mbb
Yes, we have manual splice either with a joint tape or with both clips and joint tape . Please, If you have any suggestions, email me on: mariem.khlifi@ymail.com
Electronics Forum | Sun May 05 12:06:22 EDT 2013 | mbb
Hello, I'm looking for a mechanical system for fifo management of solder paste in warehouse in order to eliminate human errors while putting solder paste jars in fridges.
Electronics Forum | Mon May 06 14:34:33 EDT 2013 | mbb
Hello, I'm looking for a supplier of red antistatic empty coils . Thank you to email me any suggestions.
Electronics Forum | Tue May 07 09:42:17 EDT 2013 | cyber_wolf
We bought a "very used" Omniflow 10 at least ten years ago. We have only replaced maybe 5 blowers in that time.
Electronics Forum | Tue May 07 12:27:23 EDT 2013 | hegemon
Seems really excessive. I am not familiar with that particular oven, but I would check to see that the fans are not seeing excess heat during use. Is there any ducting around the fans that might have leaky joints? Is there insulation around the fan
Electronics Forum | Tue May 07 13:11:33 EDT 2013 | emeto
Hi Hege, there is insulation, which when you look at looks pretty stable.I suspect that there is more heat transfer through the shaft from the propeller to the motor. However when I touch the motor it is not really hot, so I am confused what really
Electronics Forum | Wed May 22 10:39:56 EDT 2013 | emeto
Hi smter, that sounds interesting. I can even buy a wrench with a set torque if it will help. What wrench are you using?
Electronics Forum | Tue May 07 13:22:11 EDT 2013 | ngineer
Yeah, it comes on for a couple of seconds, then trips. When it comes on, before it trips, i can look into where the axis drives are, and the z-axis has a red and green led lit, while the others only have a green one. Then it trips. Maybe that drive
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Wed May 08 05:13:37 EDT 2013 | bobpan
Put up an e-mail address and i can send you a paper on setting up the current level to see if the board is working properly. The z-axis and theta-axis are swappable.....you just need to change the dip switch settings.
