Electronics Forum | Wed Jul 10 14:29:27 EDT 2013 | isd_jwendell
You wouldn't have a very good profile if you went straight from room temp to vapor temp (_-). The chamber should preheat the board before using vapor to melt the solder.
Electronics Forum | Mon Jul 15 08:11:04 EDT 2013 | emeto
I am pretty sure that is a moisture issue. You should probably bake your boards and some of your parts.
Electronics Forum | Thu Jul 18 04:42:32 EDT 2013 | ericrr
Thanks for that, sorry Im late setting (set by someone else) Speedline Bravo Top 1st chamber, 2nd, 3rd, 4th. 170° (c), 180°, 190°, 270°. Bottom 170°, 180°, 180°, 260° chain speed 27cm/second.
Electronics Forum | Sat Jul 13 17:38:20 EDT 2013 | ericrr
um thanks I have just got back into the settings and switched back on, for most of the time I have it switched on but now and again switch it off, just because "what is the difference?" at this stage I will never know.
Electronics Forum | Mon Jul 15 17:01:51 EDT 2013 | rgduval
The connector for the flex cable? Start here: http://www.te.com/catalog/feat/en/c/10232?BML=10576,24915 Cheers, ..rob
Electronics Forum | Tue Jul 16 12:39:44 EDT 2013 | ericrr
I think maybe the question was loosely directed to the three pin male terminal inside the red graphic box. But I could be wrong, I could not zoom in very much.
Electronics Forum | Sun Jul 21 09:25:44 EDT 2013 | i9300
EricR thats correct, i need to 'relocate' the power source so need a male and femal connector, that is the same as the one in the red graphic box.
Electronics Forum | Sat Aug 10 16:05:34 EDT 2013 | remon7
Sorry EricR. i am not able to give appropriate ans. U can use http://www.google.com here u will get every ans thats u want. Thanks
Electronics Forum | Tue Aug 20 08:38:32 EDT 2013 | proceng1
Remon, so your answer is to tell him to google it? What would your search criteria be?
Electronics Forum | Mon Jul 15 15:02:55 EDT 2013 | island2013
In previous lives we vacuum sealed all MSD devices. Also a nitrogen chamber can be used for unsealed bags. You can check the J-STD-033 and J-STD-020A for handling of the different levels, bake times etc. Good Luck!