Electronics Forum | Tue Feb 17 01:53:51 EST 2015 | vb7007
Hi all, We got a customer wanted us to run a PCB which is (Rigid+Flex), to be specific its looks like [T], T's leg is Flex and Top is Rigid. We have 8 TH parts and wanted to run PCBs through wave, but without damaging Flex and also we don't want to
Electronics Forum | Fri Feb 20 10:27:37 EST 2015 | emeto
If you are in standard specs, don't even mention it. THe RoHS thing in electronics becomes more and more annoying. I haven;t seen people taking out PCBs from their electronic devices and start to chew them. So it was ok to use gas with Lead for deca
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Wed Mar 25 03:27:13 EDT 2015 | slave2anubis
Hi davef, thank you for sharing this. Yes all manufacturers recommend their products, and i dont deny that they are good but for a small shop like i have i think the prices are a bit high. What i think would be a good technique, is heating the area t
Electronics Forum | Sat Feb 28 03:54:20 EST 2015 | thompson
Hi,can I help you? We make the Dual lane reflow oven in China for many years ,and in the past time we offer the machines to Flextronics and Continental automotive. can you tell me that how many zones of reflow oven you are looking for? thank you very
Electronics Forum | Mon Mar 23 15:46:23 EDT 2015 | g2garyg2
I have experience with Dual and triple lane production and perhaps can assist. I am on the PCB handling side so I am not vendor specific but more about good line flow. Many companies offer dual lane solutions today and for high volume automotive ther
Electronics Forum | Tue Feb 24 15:40:08 EST 2015 | mbartel
I'm new in this industry and need a little direction. I have a wide verity of SM parts on a board, top and bottom. The larger components have a very nice reflow, good shine. The 0402/0201's has a dull almost cold solder look. The boards function and
Electronics Forum | Wed Feb 25 21:37:12 EST 2015 | dinhhuunam
Hi Bartel , 1.1 Profile Solution to Cold Soldering Cause for Cold soldering The peak temp of reflow is too low. The preheating temp is too high and it takes too long Solution Lower the preheating temp and increase the peak temp in the reflow zone
Electronics Forum | Mon Mar 16 13:35:20 EDT 2015 | swiese242
This has been a challenge for most manufacturers. It depends on board thickness, lead or lead free paste/parts. We have a slim-kic to get the profiles correct in our 14 zone oven. I believe it may be the recently posted suggestion of too much heat in
Electronics Forum | Tue Feb 24 15:52:58 EST 2015 | swiese242
We currently have around 20k+ components in stock. I would like to have some opinions on creating a more lean manufacturing system. We check stock in our system and then order parts. Most of time leading to employees looking for parts, or shorts. We