Electronics Forum | Wed Jul 01 13:17:11 EDT 2015 | emeto
You have to keep the oil containers for the chains loaded with oil. The procedure is automatic and you will run it based on your usage. Other than that our 10zone Pyramax is running for 5years without any failure.
Electronics Forum | Mon Jun 29 08:50:55 EDT 2015 | tdemon69
looking for some one that works on these machine for a living, that my company can higher from time to time to do some work on them.
Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet
We service MPM machines. Tom Nisbet tom@goppm.com 603 765-8814 www.goppm.com
Electronics Forum | Mon Jun 29 14:44:59 EDT 2015 | ltomalino
Does anyone have the default passwords for a PCT MK3010 label applicator, or information on how to reset the passwords? Thanks in advance.
Electronics Forum | Wed Jul 01 11:48:30 EDT 2015 | sssvajunas
We use component BFU730LX and we have one problem. After reflow transistor base or collector lands are not soldered. Maybe someone have similar problems with this component? We tryed to change stencil pads (smaller , bigger) but problem is the same.
Electronics Forum | Wed Jul 01 13:57:07 EDT 2015 | circleprime
I have a customer that is requesting their flex circuit be conformally coated. Is this something that is done? Which coating would stand up to the stresses of flexing? Wouldn't that put stress on the components? Thanks! Shannon
Electronics Forum | Fri Jul 24 16:39:16 EDT 2015 | cnotebaert
have done it in the past, used silicon as it will flex,, however its not the most robust material! tends to peel/flake off.
Electronics Forum | Wed Jul 29 11:28:54 EDT 2015 | pankyb1261
How many times does it have to flex. There are acrylic conformal coatings that can be bent once to 90 degrees or so
Electronics Forum | Fri Jul 24 16:37:47 EDT 2015 | cnotebaert
to my knowledge it will always be manual insertion,, if you mean reflow, not insertion, I always apply solder to one side, reflow, then apply tacky flux pre print to the already soldered pins, print op side, assemble part then send through placement
Electronics Forum | Thu Jul 02 08:27:46 EDT 2015 | sssvajunas
Maybe someone know where company can buy MYDATA FLEX 24mm feeders(only used)? Becouse I found only Flex magazines, 32mm, 44mm feeders but not 24mm.
