Electronics Forum | Wed Oct 28 11:38:00 EDT 2009 | andoe
Does anyone know how to get a printer to work with an MCS30 system. I have limited information about printer setup.
Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite
Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Wed Oct 10 16:50:44 EDT 2001 | jeff
The "UP100 " is currently built by Speedline. However only the models UP100S (No Vision and manual adjust table ) and the UP 100MV (Vision and manual adjust table). These are batch printers not in-line. The IS model has been out of production for ab
Electronics Forum | Mon Nov 02 07:59:32 EST 2009 | shannond
Contact Greg Frazier at Automated Technology Services, he may be able to help you. He's been fixing my Fujis for a long time. greg.frazier@ats-smt.com
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Electronics Forum | Sun May 28 23:01:31 EDT 2006 | jacksaria
Hello to all, We are encountered many problems/defects in SMT lines.I would like to know your suggestion or recommendation for SMT optimization and improvement. What are the step by step solutions in order to optimized and to improve the printer, pi
Electronics Forum | Tue Oct 13 08:09:53 EDT 2009 | kudamarani08
Can anyone help me recommend or simulate a SPI and AOI machine that can balance our FUJI NXT 1 with 14 modules. We are using MPM accela printer. 200 UPH is our target. Here's the PCB dimension length(x) = 399.92mm width(y) = 141.626mm Thanks all!
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
