Electronics Forum | Fri Nov 05 08:17:44 EST 1999 | NickMata
Explain computer "overload". Specific examples would be helpful. Regards Nick
Electronics Forum | Fri Nov 05 08:13:57 EST 1999 | Stefan Witte
I would blame the line computer software. You may have a job in there which wasn't properly closed. Although I haven't experienced problems like yours, I've heard about other weird placements due to line computer's "overload".
Electronics Forum | Tue May 01 20:14:24 EDT 2001 | davef
We've been using a Glenpro 2143 Dip Tank [We offer bonus points for the wackiest retort on "dip tanks". Michael, I've got money on you.] to conformal coat boards. We can't find Glenpro. They used to be located on McBride Ave in Paterson NJ. Any c
Electronics Forum | Wed Nov 03 10:04:18 EST 1999 | PL Sasso
Hi Wes, I was very interested in your S20 problem since I am the Customer Support Center Mgr. for Siemens EAE here in the US. This sounds like a solvable problem. Most likely, due to the random nature, it involves how the vision is locating the pcb
Electronics Forum | Thu Dec 21 22:31:28 EST 2000 | Dave F
Sorry, but I'm a bit fuzzy on the goal here. Let me be basic. The basic reasons for reducing the life of products before they're shipped are: * Design qualification. This highly accelerated test beats the living stuff out of products to identify d
Electronics Forum | Wed Nov 03 03:26:38 EST 1999 | Wes
We have Siemens S-20 machine whose other gantry occasionally missmounts all its components in Y-direction(approx. 1/2 mm ). Most of the missmounts happens when there is a lot of 0603 or 0805s (B-side glue boards). Gantry picks up the components OK bu
Electronics Forum | Wed Oct 13 12:24:08 EDT 2004 | davef
Consider: * Equipment Coating dip tank Glenpro (2143 dip tank) 39 McBride Ave., Paterson, NJ 07501-1715 * Equipment Coating dip tank CCRCo 1954 Placentia Ave. Suite 107 Costa Mesa, CA 92627 800-443-2726 949-574-1360 Fax 1368 info@CCRCo.com ht
Electronics Forum | Wed Nov 03 04:02:51 EST 1999 | Wolfgang Busko
Hi Wes, it may not be the same but I had a problem with one Phillips machine which started unpredictible mismounting all components about 1mm. When it occured you couldn�t get it do it right again unless you turned it down and restarted it. The servi
| 1 |
