Electronics Forum | Mon Sep 24 18:03:43 EDT 2012 | rmazenha
Hi, i am using AIM 264-5 No Clean flux for soldering alpaca pieces on PCB boads, but i am having problems: poor filling and no solder. I am using SAC 305 lead free solder. I have tried to change flux pressure, time, ammount as well solder speed an
Electronics Forum | Mon Nov 01 15:47:21 EST 1999 | Jim Snipes
Dave thaanks for your quick reply. The flow through probelm exists on several component, Examples; small Tan electolic caps.,electrolic epoxy caps. and one specfic lad on a resistor network. I have veried conveyor speed and readjusted heat sett ings
Electronics Forum | Thu Mar 04 12:00:56 EST 2004 | tryn
I am looking at two different type fluxes, Kester 951nc and AIM 264-5nc. The two seem to be comparable, but the Kester is listed as an ORL0 and the AIM as a ROL0. My product builds are all military and I have been dictated to use only ROl0 flux. I kn
Electronics Forum | Sat Oct 01 11:48:45 EDT 2005 | Hiram
Hello everybody, We are in the process of implementing NC process on the wave solder. We have a Sonotek XL fluxing system. Any ideas out there? Solder used: SN100C Flux options so far: 264-5 flux, 270WR VOC-free 9both from AIM solder) The flux ch
Electronics Forum | Mon Feb 10 17:04:35 EST 2014 | globalpowerproducts
I am having a problem producing clean boards when i run them through my new machine. Currently i use an Electrovert system that uses trays and we are trying to upgrade our equipment so I bought a SHEO 8250 and it is making the boards dirty and lots o
Electronics Forum | Tue Nov 02 17:52:17 EST 1999 | Dave F
Jim: Several points: 1 If you�re correct about corrosion of your component leads (which is entirely possible if the leads are steel, as you say), then the AIM 264-5 no-clean may not be aggressive enough to remove the corrosion you are seeing routin
| 1 |
