Electronics Forum: 28

ESD Safe Fasteners

Electronics Forum | Tue Jun 25 18:28:32 EDT 2002 | genny

What about a twist tie? Reusable.

Point to Ground Measurement

Electronics Forum | Thu Apr 20 17:28:32 EDT 2006 | GS

The simple way should be to wire the ground according to your National Safety Standards. Regards........GS

Freshman in SMT industry needing advice

Electronics Forum | Mon Mar 08 08:28:32 EST 2004 | pjc

New Stencil Cleaning machine on the scene. Saw it at APEX 04, manufactured in West Viginia. http://www.pressureproducts.com/SPPC_Hm.htm

No access to Search Results

Electronics Forum | Tue Dec 07 20:28:32 EST 2004 | jjwhite

Why can't I access some of the messages found with searches? Ex: search for "Chain lubrication" has 9 results. Only the last 4 (in 2002) appear even though I click on newer ones. This is not the only search that produced these types of weird things.

Fuji Feeder Pitch

Electronics Forum | Sun Jul 31 23:28:32 EDT 2005 | saiwong

Fuji will not sell the reel by itself. also, you need to change the tape guide to 0.7 in order to place the 0402. Tape guide cost you almost a hundred bucks. I don't think it is a good idea to modify the feeder.

CP6 placement problems

Electronics Forum | Wed May 02 11:28:32 EDT 2007 | Scotceltic

Might seem too simple but make sure your fids are defined and locking on correctly. Also, run frequent center checks on your nozzles.

Key Points to be considered while buying Ionic Contamination Tester

Electronics Forum | Thu Oct 29 07:28:32 EDT 2015 | prameel_84

Request you to spell out the key points to be considered for purchasing Ionic Contamination Tester

conductive fill via

Electronics Forum | Mon Nov 11 11:28:32 EST 2002 | davef

Sand is not a great conductor, compared to copper. Never heard of using the stuff on RF boards. Our board fabricator uses Dupont CP100, now CP101, [or something like that cuse who's going to check?] when plugging via on cheap boards. Your board fa

Laser Depanelizers

Electronics Forum | Fri Oct 29 05:28:32 EDT 2004 | dj_jago

I think you would be better off designing routing slots into your panel and then use a high speed router to cut out the PCBs. PMJ Automec/Cencorp make such equipment (I used to work for them) but have no affiliation to them anymore. Alot of peopl

Component Feeder Sizes

Electronics Forum | Wed Jun 17 04:27:49 EDT 1998 | Terry Keen

I am involved in the purchasing decision (Technical side) of which placement machine to buy. One of the criteria we need to specify is how many feeders, and what sizes. I have a provitional parts list of a job that we are most likly going to build. T

  1 2 Next

28,32 searches for Companies, Equipment, Machines, Suppliers & Information