Electronics Forum: 4.5 (Page 1 of 23)

AOI

Electronics Forum | Wed Oct 17 09:13:50 EDT 2012 | sfeinsp

How to turn OFF message "Solder Insp OFF" on Mirtec 4.5.5.0 program

Stencil Manufacturer

Electronics Forum | Mon Mar 13 10:03:34 EDT 2017 | oxygensmd

Depends on where are you located? If you are from EU, I can recommend a 4-5 manufacturer.

Baking Moisture Sensitive Components >4.5mm

Electronics Forum | Mon Jan 22 14:22:46 EST 2007 | muse95

Actually, I've been looking into this myself, and the B version doesn't help any more than the A version. The tables still only go to 4.5mm. And Appendix B has a bunch of formulas with undefined variables that I haven't been able to figure out. An

Fuji CP 642 Communication Cables with Flexa

Electronics Forum | Tue Jul 02 10:57:29 EDT 2019 | BigFuji642

Are the pinouts for the cable mirrored (like normal Male to Female DB pinouts)? Like the Male pins when looking straight at them are 1 2 3 4 5 and the female when looking straight at it is 5 4 3 2 1 Or is it that they are not mirrored and both ar

Shoot Up Reflow Zone

Electronics Forum | Mon Jan 30 22:45:30 EST 2017 | cmarasigan

Hello Marc, Thank you for the recommendation. I've contacted our local service support. We found out that heat coming from higher zones 7, 8 & 9 overflows to zone 3, 4 & 5 which affects actual temp reading at Z3,4,5. Since we already replaced some b

28 pin QFN Pads.

Electronics Forum | Thu Sep 16 17:56:48 EDT 2010 | asksmt

Ok Thanks, i have reduced thermal pad size by 4.5 mils on top and bottom part of this footprint where the problem was occuring, so now the clearance between thermal pad and lead pads are 12 mils instead of 7.5 mils on two sides. (i kept the signal pa

Looking For Platform Set-up Validation (PSV) for UPS 4.5e (OS/2) Software

Electronics Forum | Fri Apr 17 12:09:21 EDT 2015 | ilavu

Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial

Thermocouples

Electronics Forum | Wed Jan 31 11:53:39 EST 2001 | rocky1

Looking for another source beside Omega! We buy the Omega brand 5SC-TT-K-36-36. Omega's lead-time on this stuff is 4-5 weeks. Can anyone help?

8 years old parts. how it could be...

Electronics Forum | Thu Sep 16 03:53:04 EDT 1999 | park kyung sam

Can you imagine that there is a smt process using the a few chip and ic are nearly about 4,5,6,8 years old. Antigues?? what should you do If you are an engineer of smt process in that company. thank in advance.

BGA's Reworks

Electronics Forum | Wed Mar 26 15:46:43 EST 2003 | Ren�

To remove or Place a BGA in a BGA reworks machine , do I have to do a same profile as a normal Oven ( around 4.5 mins to Peak time ) or the conditions are only to get temperature needed to Solder or Remove ( no matters Time).

  1 2 3 4 5 6 7 8 9 10 Next

4.5 searches for Companies, Equipment, Machines, Suppliers & Information