Electronics Forum: 4230 (Page 1 of 1)

Temp Profile for 0.05 pitch

Electronics Forum | Sun Mar 01 17:54:26 EST 1998 | Mike Mihld

Can anyone advise a good starting point for a temp profile for on 0.05" and 1206 component boards? These boards are simple by todays standards and do not contain any fine pitch or other special components. Thanks in advance... MM

Re: Temp Profile for 0.05 pitch

Electronics Forum | Thu Mar 05 16:29:22 EST 1998 | Brian Stumm @ ETS

Can anyone advise a good starting point for a temp profile for on 0.05" and 1206 component boards? These boards are simple by todays standards and do not contain any fine pitch or other special components. Thanks in advance... MM Be hap

Re: Temp Profile for 0.05 pitch

Electronics Forum | Mon Mar 02 09:45:08 EST 1998 | Justin Medernach

Can anyone advise a good starting point for a temp profile for on 0.05" and 1206 component boards? These boards are simple by todays standards and do not contain any fine pitch or other special components. Thanks in advance... MM Mike,

Re: Temp Profile for 0.05 pitch

Electronics Forum | Mon Mar 02 23:08:50 EST 1998 | Scott McKee

Can anyone advise a good starting point for a temp profile for on 0.05" and 1206 component boards? These boards are simple by todays standards and do not contain any fine pitch or other special components. Thanks in advance...

Re: Where's Earl Moon ?

Electronics Forum | Wed May 17 08:12:13 EDT 2000 | Earl Moon

Well Dave, You've done it again. Where do you come, no dig up this stuff. Not at all offended about the Montana floss crap, while sitting on my Montana porch with a baudacious set of my own sitting nearby attached to what I cherish most - a Nancy lo

  1  

4230 searches for Companies, Equipment, Machines, Suppliers & Information