Electronics Forum | Tue Feb 21 18:32:12 EST 2012 | skatemo
Hello estimated Someone can help me with a problem that I have in one cp643 which marks the stations 17 and 19 of almost all the holders, already there changed the amplifiers of both stations and were calibrated but it follows the problem. Thanks.
Electronics Forum | Mon Feb 27 13:02:34 EST 2012 | cyber_wolf
The clutches are dirty and slipping. Sincerely, Estimated
Electronics Forum | Tue Feb 28 21:18:49 EST 2012 | skatemo
Hello friend, also cleans the clutches, several times but he continues presenting the same problem. I suspect in a few holders that we buy, for that from that they established themselves I present this fault
Electronics Forum | Wed Feb 29 10:00:48 EST 2012 | cyber_wolf
In order to clean the clutches properly, you must disassemble them. Did you do that ? The nozzle holder sensor dogs must be clean and scratch free.
Electronics Forum | Tue Oct 02 10:26:17 EDT 2012 | jimmyboz
If I had a choice I would choose a CP642 90% of the time. The loading system on the 643 can load 2 PCBs at the same time but is complicated. If 2 seconds on PCB load time is critical on your production choose the 643, if not, choose the 642.
Electronics Forum | Fri Jul 27 03:57:55 EDT 2018 | robl
Just found my notebook from the late 90's, 643 confirmed 0201 from the factory, 642 needed the upgraded camera from the 643.
Electronics Forum | Thu Dec 27 11:07:19 EST 2007 | kpm135
Can anyone tell me the differences between the CP6-4000 and the CP643? Is the CP643 able to place a wider component range? Does the CP643 have some sort of vision system while the CP6-4000 doesn't? If anyone has the Fuji Specs on the CP643 and could
Electronics Forum | Sat May 16 07:53:57 EDT 2009 | peteralmendrala
although the cp643 is much upgraded and a little bit more complicated to those person whos luck of technical skills, i would still prefer to use this machines because it would give you more productivity than cp6400. on the mechanical aspec of these t
Electronics Forum | Thu Aug 07 11:17:51 EDT 2003 | 51165
Can someone help me with a Ref Side Clamp Mesh Error on a CP643E?
Electronics Forum | Mon May 23 22:30:36 EDT 2005 | Frank
Hi all, I am trying to solve a problem with a CP643E any help on it please,It stop during production on an error for (Outside Target Position). Cheers Frank
