Electronics Forum: a and t and f and 3240 and wave and soldering and machine (Page 1 of 1)

Re: Desoldering of TSOP and TSOJ

Electronics Forum | Sun Jan 10 08:44:32 EST 1999 | Dave F

| | | HI! I am a package engineer in Korea. I have some reasons | | | to desolder excessive solder at the lead of TSOP and TSOJ | | | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. |

Wave Soldering and Through Hole Forums

Electronics Forum | Thu Jan 24 13:23:53 EST 2002 | Shawn

Thank you all very much for the responses. The solder is eutectic and the problem, as far as I can tell, has been around before I was here, 2+ years. The flow machine is a treiber with 2 bottom preheaters and 1 top. The solder pot temp is 500F +/-4F

Wave Soldering and Through Hole Forums

Electronics Forum | Thu Jan 24 19:58:58 EST 2002 | davef

for regular eutecticish solders, keep the pot temperature between 230�C [446�F] and 290�C [554�F]. If you polled us on our pot temperatures, we�d be all over the map, but with more lower than higher than you. High pot temperatures tend to generate

Foam fluxer maintenance, storage and cleaning

Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef

Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept

  1  

a and t and f and 3240 and wave and soldering and machine searches for Companies, Equipment, Machines, Suppliers & Information