Electronics Forum | Fri Jul 28 13:28:15 EDT 2000 | Claudine Corda
Technical Devices in Calif also makes a 24" wave. -Claudine
Electronics Forum | Thu Apr 16 05:50:25 EDT 2015 | sarason
Do you mean a 24V Linear Actuator ? sarason
Electronics Forum | Wed Jun 25 12:48:51 EDT 2008 | sleech
I would love to see the documentation of the experiment that indicated that a 24-hour/70 degree C bakeiing cycle at 10Pa is more effetive than a 24-hour 125 deg C baking cycle at normal atmosphere. We have looked at the old Levey-Perlmann paper and f
Electronics Forum | Thu Apr 28 11:08:19 EDT 2005 | pr
I would also say that using 11,000 cph (best time) is an overestimate. Why not take the avg components placed over a 24 hr. period and get your cph from that? just a thought, pr
Electronics Forum | Thu Mar 15 17:28:44 EST 2001 | rentreo
Sounds like a problem I ran into recently. In my case it was a problem with via holes which were used as test points on our in-circuit tester. My problem was caused by moisture in the boards. My cure was a 24 hour bake at 100 deg c.
Electronics Forum | Wed May 12 19:14:53 EDT 2004 | russ
We use Samsungs and have never encountered a 24mm with 4mm pitch. I actually have Samsung coming in tomorrow and we will reply. Russ
Electronics Forum | Wed Sep 13 10:22:25 EDT 2006 | james
I'm also looking for a printer that can handle a 24 inch long board? Any suggestions out there? Thanks
Electronics Forum | Mon Jan 29 20:12:18 EST 2007 | davef
Continuing with Darby's point, the surface area of the pin that is in contact with solder is HUGE. You could pound that pin with a 24oz ball peen hammer and not get it to release from the copper in that through hole.
Electronics Forum | Mon Jan 12 23:25:27 EST 2009 | sachu_70
Did you try explaining the problem to your machine manufacturer for direct assistance? Perhaps your machine brochure would indicate a 24hrs helpline service, or any contact no.
Electronics Forum | Tue Sep 17 07:42:27 EDT 2002 | cyber_wolf
Hi, We have a serious problem bending our 24mm tape covers. In particular we are feeding a 24mm 16 pitch tape on a 24mm P8 feeder.The component is a plcc28,the tape cover is a AMCD3107 5.0 When the tape covers come in from Fuji the fingers that cove
