Electronics Forum | Fri Sep 17 10:39:23 EDT 1999 | Earl Moon
| | | | | | | Hi, Can someone tell me how can I identify a finished product which make by SMT technology or not ? We assembly memory modules now and want to diversify our products range now. | | | | | | | | | | | | | | Thanks !!!!! | | | | | | | |
Electronics Forum | Wed Aug 11 09:51:11 EDT 1999 | Brian
| | | Easy goods-in polymerisation check: clean, white, cotton cloth: wrap it round a suitably gloved finger and pour a few drops of methylene chloride (! toxic) onto the end of the finger and rub it onto the bare board for a minute or so. If it come
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
Electronics Forum | Sat Jul 10 02:47:27 EDT 1999 | Scott
| | | Hi! | | | I'm a process engineer attempting to do a capability study on our existing convection reflow oven - Heller 1500. It was recommended by an independent consultant to do at the very least, load testing, process ready testing, and board
Electronics Forum | Sat Jun 12 16:45:48 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Sat Jun 12 17:41:13 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Tue Jun 15 16:37:17 EDT 1999 | Philip Kazmierowicz
| | | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like
Electronics Forum | Sun May 30 18:34:04 EDT 1999 | Earl Moon
| | | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accord