Electronics Forum: adjustable conveyor (Page 1 of 15)

SMEMA conveyor

Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika

I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not

Omniflow 7 conveyor

Electronics Forum | Mon Jan 15 15:42:45 EST 2007 | realchunks

Dback is right. You're missing part of your manual. Once you perform steps 5-7 you should get an indication that you calibrated correctly. Man, it's a cardinal sin to recal conveyors once you have programs adjusted. Why did you feel the need to

wave soldering conveyor angle

Electronics Forum | Sun May 09 06:34:53 EDT 2004 | alex

i want to know that friends what is the angle of conveyor in wave soldering machine to get good soldering , can we adjust angle

Omniflow 7 conveyor

Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer

This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to

wave soldering conveyor angle

Electronics Forum | Mon May 10 07:53:30 EDT 2004 | pjc

most machines have fixed angle of 6 deg. some are adjustable from 5 - 7 deg., but 6 is most popular.

wave soldering conveyor angle

Electronics Forum | Mon May 10 20:16:02 EDT 2004 | wdlau

it can adjusted per the machine and your boards, Not a fix for every board, also if you are talking about the LF wave soldering process, it should be moved to largr angle compared to the tranditional sn/pb soldering

Omniflow 7 conveyor

Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc

We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w

Omniflow 7 conveyor

Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer

Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch

Universal conveyor help

Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag

Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma

Connecting ASYS conveyor to TCM 3500Z

Electronics Forum | Thu Aug 21 10:14:57 EDT 2014 | malard

I know my Sanyo machine is no longer made, and the Sanyo connector has died out, but I have an ASYS TRM-03 conveyor that I want to connect up to it, in the manual it references Sanyo for its output format by adjusting a couple of jumpers. However the

  1 2 3 4 5 6 7 8 9 10 Next

adjustable conveyor searches for Companies, Equipment, Machines, Suppliers & Information