Electronics Forum: after (Page 266 of 656)

Dye and Pry on PoPs?

Electronics Forum | Fri Aug 19 02:16:40 EDT 2011 | ppcbs

In my opinion destructive methods went out with the stone age. At least they did at our company. We specialize in non-destructive defect analysis. We can determine where the failure is i.e. assembly process, fab defect, BGA defect or plating proce

Un-reworkable Glue type

Electronics Forum | Fri Aug 19 05:20:40 EDT 2011 | kemasta

Hi! I am searching for a glue type which use for security purpose. The glue must not able to rework after full cure and fast curing time (within 5~10minutes). I have some sample in hand, but it seem quite expensive considering the volume that I am

QFP footprint -extended outside pad?

Electronics Forum | Fri Sep 16 14:51:06 EDT 2011 | isd_jwendell

I recently did a layout for a Freescale accelerometer and the mfg recommended pad layout did something similar. They where very specific in the pad layout dimensions. They stated the reason was "With the correct footprint, the packages will self-alig

Dek 265 GSX Error message

Electronics Forum | Mon Sep 19 11:29:33 EDT 2011 | padawanlinuxero

Hello guys ! I have a problem with a DEK 265 GSX, sometimes after download the vision or during, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE Now for a few weeks it gave me

Loud humming noice from X-Wagon motor

Electronics Forum | Sat Oct 29 12:53:34 EDT 2011 | dontfeedphils

We had the same motor problem with our My12, whenever we would get the sound we would go through and slow down X accel speed in any packages and the placement accuracy as well. After doing this for quite a while we finally tried updating the motor c

Conformal Coating

Electronics Forum | Wed Nov 09 16:57:05 EST 2011 | tombstonesmt

If we were to apply a thixotropic gel into a keep out area what would the removal process be? We have keep out areas that are later used for mounting purposes so the customer requests no residue in these areas. As I previously stated, we're using mas

Dark Solder Joint

Electronics Forum | Fri Nov 25 04:10:21 EST 2011 | bwjm

Hi, I am facing some problems on my soldering joint. My operators perform the solder and left the assembled PCBs on the WIP rack. After 1 week (Due to shortage of components),the solder joint of the components darken. Is it caused by oxidation? If ye

Need help for contact 3AV (2001 YOM )

Electronics Forum | Wed Dec 07 07:07:32 EST 2011 | haiae

Thank you for your opinion. After did some works I knew the reason and solved it. If any one who may be get similar trouble please contact me, I'll show you how to do. Hard work today for better tomorrow is my trend.

transducers out of sync error, Mydata TP-11

Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk

I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with

SMD component 7918

Electronics Forum | Mon May 07 21:08:19 EDT 2012 | abyan

Hi..I need help again.. I need negative 18 volt linier voltage regulation, but after I search for a while, all of the components with this spec is obsolete, an the only exixting component is the through hole one.. Can you show me where I could find a


after searches for Companies, Equipment, Machines, Suppliers & Information